*: Use the GTS.
| Proceed to |
|---|
| NEXT |
NEXT
| Proceed to |
|---|
| NEXT |
NEXT
If the display indicates a communication fault with the GTS, inspect the DLC3.
| Proceed to |
|---|
| NEXT |
NEXT
Check for DTCs and freeze frame data.
Record or print DTCs and freeze frame data if necessary.
| Proceed to |
|---|
| NEXT |
NEXT
Clear the DTCs and freeze frame data.
| Proceed to |
|---|
| NEXT |
NEXT
| Proceed to |
|---|
| NEXT |
NEXT
Confirm problem symptoms.
If the engine does not start, first perform the "Check DTC" and "Conduct Basic Inspection" procedures below.
| Result | Proceed to |
|---|---|
| Malfunction occurs | A |
| Malfunction does not occur | B |
A
B
Check for DTCs.
Refer to DTC Check / Clear.
| Result | Proceed to |
|---|---|
| DTC is output | A |
| DTC is not output | B |
A
B
Conduct basic inspection.
Refer to Basic Inspection.
Click hereEngine / Hybrid System>1AD-FTV ENGINE CONTROL>ECD SYSTEM>BASIC INSPECTION
| Result | Proceed to |
|---|---|
| Malfunctioning parts not confirmed | A |
| Malfunctioning parts confirmed | B |
A
B
Refer to Problem Symptoms Table.
Click hereEngine / Hybrid System>1AD-FTV ENGINE CONTROL>ECD SYSTEM>PROBLEM SYMPTOMS TABLE
Also, refer to the inspection procedure for the problem symptom.
| Proceed to |
|---|
| NEXT |
NEXT
| Proceed to |
|---|
| NEXT |
NEXT
| Proceed to |
|---|
| NEXT |
NEXT
| Proceed to |
|---|
| NEXT |
NEXT
| Proceed to |
|---|
| NEXT |
NEXT