Home › Engine / Hybrid System › 1AD-FTV ENGINE CONTROL › ECD SYSTEM › 2012.12–2015.10
RM3090E _51 Engine / Hybrid System _008729 1AD-FTV ENGINE CONTROL _0058550 ECD SYSTEM C

1AD-FTV ENGINE CONTROL  ECD SYSTEM  U1103  Lost Communication with Stop and Start Control Module  


DESCRIPTION

The ECM and engine stop and start ECU communicate with each other via CAN communication. The engine stop and start ECU also communicates with other ECUs through the ECM. If there is a problem with this communication, the ECM illuminates the MIL and sets this DTC.

DTC No. Detection Item DTC Detection Condition Trouble Area MIL Memory
U1103 Lost Communication with Stop and Start Control Module No communication between ECM and engine stop and start ECU (1 trip detection logic).
·

ECM to engine stop and start ECU circuit

·

ECM

·

CAN communication system


Does not come on DTC stored

CONFIRMATION DRIVING PATTERN

DTC Detection Drive Pattern
DTC No. DTC Detection Drive Pattern
U0101 Ignition switch ON

WIRING DIAGRAM

A293661
0.156,2.323 3.01,2.563 2.854,0.24 10 false Engine Stop and Start ECU 1.021,0.667 1.458,0.844 0.438,0.177 10 false CANH 1.031,1.219 1.469,1.396 0.438,0.177 10 false CANL 1.5,0.51 1.938,0.688 0.438,0.177 10 false 15 1.5,1.073 1.938,1.25 0.438,0.177 10 false 16 0.156,2.167 0.594,2.344 0.438,0.177 10 false G87 3.896,2.448 5.667,2.625 1.771,0.177 10 false : CAN Communication Line 5.688,0.688 6.208,0.865 0.521,0.177 10 false CANH 5.688,1.24 6.208,1.417 0.521,0.177 10 false CANL 5.521,0.5 6.042,0.677 0.521,0.177 10 false 7 5.51,1.063 6.031,1.24 0.521,0.177 10 false 6 5.833,2.167 6.354,2.344 0.521,0.177 10 false A61 6.271,2.167 6.792,2.344 0.521,0.177 10 false ECM

CAUTION / NOTICE / HINT

HINT:
·

When DTCs indicating a CAN communication system malfunction are output, repair the CAN communication system before repairing each corresponding sensor.

·

Read freeze frame data using the GTS. Freeze frame data records the engine condition when malfunctions are detected. When troubleshooting, freeze frame data can help determine if the vehicle was moving or stationary, if the engine was warmed up or not, and other data from the time the malfunction occurred.

·

If the CAN communication system is malfunctioning, there is no data output from the ECM. In this case, some of the freeze frame data will not be correct and not identical with the ECM data, but the ECM data are correct.



PROCEDURE

1.GO TO CAN COMMUNICATION SYSTEM

NEXT

END