Refer to DTC P0180 (Click here Engine / Hybrid System>2AD-FHV ENGINE CONTROL>ECD SYSTEM>P0180).
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | MIL | Memory |
|---|---|---|---|---|---|
| P0168 | Fuel Temperature Too High | All of following conditions are met (1 trip detection logic):
·
The engine speed is more than 1400 rpm. ·
The vehicle speed is more than 10 km/h (6.25 mph). ·
The fuel temperature is 110°C (230°F) or higher for 1 second or more. |
Fuel lines or fuel filter clogged | Comes on | DTC stored |
| DTC No. | DTC Detection Drive Pattern |
|---|---|
| P0168 | Drive vehicle at high speed or with heavy load (Use freeze frame data from time malfunction occurred as reference while driving) |
After replacing the supply pump assembly, the ECM needs initialization (Click here Engine / Hybrid System>2AD-FHV ENGINE CONTROL>ECD SYSTEM>INITIALIZATION).
Read freeze frame data using the GTS. Freeze frame data records the engine condition when malfunctions are detected. When troubleshooting, freeze frame data can help determine if the vehicle was moving or stationary, if the engine was warmed up or not, and other data from the time the malfunction occurred.
Connect the GTS to the DLC3.
Turn the ignition switch to ON and turn the GTS on.
Enter the following menus: Powertrain / Engine / Trouble Codes.
Read the DTCs.
| Proceed to |
|---|
| DTC P0168 is output |
| DTC P0168 and other DTCs are output |
If any DTCs other than P0168 are output, troubleshoot those DTCs first.
DTC P0168 is output
DTC P0168 and other DTCs are output
Perform a visual inspection of the exterior of the supply pump assembly and check that there are no fuel leaks.
There are no fuel leaks or stains.
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Replace the fuel filter element assembly.
Click hereEngine / Hybrid System>2AD-FHV FUEL>FUEL FILTER>REPLACEMENT
| Proceed to |
|---|
| NEXT |
NEXT
Replace the supply pump assembly.
Click hereEngine / Hybrid System>2AD-FHV FUEL>FUEL SUPPLY PUMP>REMOVAL
| Proceed to |
|---|
| NEXT |
NEXT
Bleed the air from the fuel system.
Click hereEngine / Hybrid System>2AD-FHV FUEL>FUEL SYSTEM>ON-VEHICLE INSPECTION
| Proceed to |
|---|
| NEXT |
NEXT
Perform supply pump initialization.
Click hereEngine / Hybrid System>2AD-FHV ENGINE CONTROL>ECD SYSTEM>INITIALIZATION
| Proceed to |
|---|
| NEXT |
NEXT
Connect the GTS to the DLC3.
Start the engine.
Turn the GTS on.
Clear the DTCs.
Enter the following menus: Powertrain / Engine / Data List / Fuel Temperature.
| Tester Display |
|---|
| Fuel Temperature |
Drive the vehicle in a city area and check that the value of Fuel Temperature does not exceed 110°C (230°F).
| Proceed to |
|---|
| NEXT |
NEXT