Home › Engine / Hybrid System › 2AD-FTV ENGINE CONTROL › ECD SYSTEM(for CCo)
RM3090E _51 Engine / Hybrid System _008377 2AD-FTV ENGINE CONTROL _0049703 ECD SYSTEM(for CCo) D

2AD-FTV ENGINE CONTROL  ECD SYSTEM(for CCo)  INITIALIZATION  


INITIALIZATION PROCEDURE FOR DIESEL THROTTLE BODY ASSEMBLY AND ELECTRIC EGR CONTROL VALVE ASSEMBLY


HINT:

When the diesel throttle body assembly or electric EGR control valve assembly is replaced, perform initialization


a.

Turn the ignition switch to ON.

NOTICE:

Do not start the engine.



b.

Turn the ignition switch off and wait for 30 seconds or more.


c.

Turn the ignition switch to ON and wait for 10 seconds or more.



SUPPLY PUMP INITIALIZATION PROCEDURE


HINT:

After replacing the supply pump and/or ECM:

·

If the engine is defective or stalls immediately after startup, the learned values of the ECM must be initialized. The engine can be initialized through the GTS or by short circuiting DLC3 terminals.

·

If the engine starts normally, initialization is not necessary. Perform steps procedure "A" and procedure "B" only.



a.
A297971

Connect the GTS to the DLC3.


b.

Turn the ignition switch to ON.

NOTICE:

Do not start the engine.



c.

Turn the GTS on.


d.

Enter the following menus: Powertrain / Engine and ECT / Utility / Supply Pump Initialization.

Powertrain > Engine > Utility
Tester Display
Supply Pump Initialization
50005 61 163

e.

Press "Next".


f.
A297972

Press "Next".


g.
A297973

Press "Exit".


h.

Start the engine to check if the initialization is complete. If the engine cannot be started, repeat the initialization procedures from the beginning. (Procedure "A")


i.

Idle the engine for at least 1 minute under the following conditions: (Procedure "B")

·

The engine coolant temperature is 60°C (140°F) or higher.

·

The fuel temperature is 20°C (68°F) or higher.


NOTICE:

Do not race the engine immediately after starting the engine. After warming up the engine, racing the engine is acceptable.


HINT:
·

The engine coolant temperature can be estimated by touching the outlet hose.

·

The fuel temperature can be estimated by using the ambient temperature as a substitute.

·

If the engine coolant temperature is difficult to estimate, use the GTS and enter the following menus: Powertrain / Engine and ECT / Data List / Coolant Temp.




j.

Initialization is complete.



CRANK TIME COMPENSATION RESET FUNCTION


·

This procedure uses the GTS to perform "Crank Time Compensation Reset".

·

When replacing the timing rotor (engine assembly), perform "Crank Time Compensation Reset".


HINT:
·
A204035

If an error occurs during compensation reset, check the vehicle condition, and then perform compensation reset again.

·

A communication malfunction may occur if there is a problem with the ECM, a wire harness or the connection to the DLC3. If the wire harnesses and the connection to the DLC3 are inspected and found to be normal, the ECM may be malfunctioning.



a.

Connect the GTS to the DLC3.


b.

Turn the ignition switch to ON.

NOTICE:

Do not start the engine.



c.

Turn the GTS on.


d.

Enter the following menus: Powertrain / Engine and ECT / Utility / Crank Time Compensation Reset.

Powertrain > Engine > Utility
Tester Display
Crank Time Compensation Reset
50005 61 237

e.
A297974

When the first screen is displayed, check the vehicle condition and push "Next".


f.
A297975

When the screen indicating reset completion is displayed, push "Exit".