The ECM of this system is connected to the CAN communication system. Therefore, before starting troubleshooting, be sure to check that there is no trouble in the CAN communication system.
*: Use the GTS.
| Proceed to |
|---|
| NEXT |
NEXT
Refer to How to Troubleshoot ECU Controlled Systems in the Introduction section.
Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING
| Proceed to |
|---|
| NEXT |
NEXT
11 to 14 V
If the voltage is below 11 V, recharge or replace the battery before proceeding.
| Proceed to |
|---|
| NEXT |
NEXT
| Proceed to |
|---|
| NEXT |
NEXT
Refer to DTC Check/Clear.
Click hereDrivetrain>K111 MULTIDRIVE / CVT>CONTINUOUSLY VARIABLE TRANSAXLE SYSTEM>DTC CHECK / CLEAR
| Proceed to |
|---|
| NEXT |
NEXT
| Proceed to |
|---|
| NEXT |
NEXT
Refer to Check Mode Procedure.
Click hereDrivetrain>K111 MULTIDRIVE / CVT>CONTINUOUSLY VARIABLE TRANSAXLE SYSTEM>CHECK MODE PROCEDURE
| Proceed to |
|---|
| NEXT |
NEXT
Refer to Road Test.
Click hereDrivetrain>K111 MULTIDRIVE / CVT>CONTINUOUSLY VARIABLE TRANSAXLE SYSTEM>ROAD TEST
| Proceed to |
|---|
| Symptom does not occur |
| Symptom occurs |
Symptom does not occur
Symptom occurs
Refer to Electronic Circuit Inspection Procedure.
| Proceed to |
|---|
| NEXT |
NEXT
Refer to DTC Check/Clear.
Click hereDrivetrain>K111 MULTIDRIVE / CVT>CONTINUOUSLY VARIABLE TRANSAXLE SYSTEM>DTC CHECK / CLEAR
| Proceed to |
|---|
| DTC is not output |
| DTC is output |
DTC is not output
DTC is output
Refer to Park/Neutral Position Switch.
Click hereDrivetrain>K111 MULTIDRIVE / CVT>PARK / NEUTRAL POSITION SWITCH>ON-VEHICLE INSPECTION
Refer to Shift Lever.
Click hereDrivetrain>K111 MULTIDRIVE / CVT>SHIFT LEVER>ON-VEHICLE INSPECTION
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Refer to Mechanical System Test.
Click hereDrivetrain>K111 MULTIDRIVE / CVT>CONTINUOUSLY VARIABLE TRANSAXLE SYSTEM>MECHANICAL SYSTEM TESTS
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Refer to Hydraulic Test.
Click hereDrivetrain>K111 MULTIDRIVE / CVT>CONTINUOUSLY VARIABLE TRANSAXLE SYSTEM>HYDRAULIC TEST
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Refer to Problem Symptoms Table.
Click hereDrivetrain>K111 MULTIDRIVE / CVT>CONTINUOUSLY VARIABLE TRANSAXLE SYSTEM>PROBLEM SYMPTOMS TABLE
| Proceed to |
|---|
| OK |
| NG |
OK
NG
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Refer to Diagnostic Trouble Code Chart.
| Proceed to |
|---|
| NEXT |
NEXT
| Proceed to |
|---|
| NEXT |
NEXT
| Proceed to |
|---|
| NEXT |
NEXT
| Proceed to |
|---|
| NEXT |
NEXT
| Proceed to |
|---|
| NEXT |
NEXT