The ECM receives signals sent from the skid control ECU via the CAN communication system. When DTCs indicating a CAN communication system malfunction are output, repair the CAN communication system before repairing each corresponding ECU or sensor.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | MIL | Memory |
|---|---|---|---|---|---|
| U0129 | Lost Communication with Brake System Control Module | 1. Diagnosis Condition 2. Malfunction Status 3. Malfunction Time 4. Other
1.
The ignition switch is ON. 2.
There is no communication between the ECM and skid control ECU. 3.
2.4 seconds 4.
1 trip detection logic |
·
CAN communication system ·
Skid control ECU (Brake actuator assembly) ·
ECM |
Comes on | DTC stored |
Clear the DTCs.
Click hereDrivetrain>K111 MULTIDRIVE / CVT>CONTINUOUSLY VARIABLE TRANSAXLE SYSTEM>DTC CHECK / CLEAR
Write down the currently output DTCs before clearing them.
Start the engine and drive the vehicle at a low speed.
| Proceed to |
|---|
| NEXT |
NEXT
Connect the GTS to the DLC3.
Turn the ignition switch to ON.
Turn the GTS on.
Enter the following menus: Powertrain / Engine and ECT / Trouble Codes.
Read the DTCs using the GTS.
| Proceed to |
|---|
| U0129 is not output |
| U0129 is output |
U0129 is not output
U0129 is output