Home › Vehicle Interior › SEAT › FRONT POWER SEAT CONTROL SYSTEM(w/ Memory) › 2012.12–2016.08
RM3090E _58 Vehicle Interior _008433 SEAT _0062871 FRONT POWER SEAT CONTROL SYSTEM(w/ Memory) Y

SEAT  FRONT POWER SEAT CONTROL SYSTEM(w/ Memory)  HOW TO PROCEED WITH TROUBLESHOOTING  


CAUTION / NOTICE / HINT

HINT:
·

Use the following procedure to troubleshoot the front power seat control system.

·

*: Use the GTS.



PROCEDURE

1.VEHICLE BROUGHT TO WORKSHOP
Result:
Proceed to
NEXT



NEXT

2.CUSTOMER PROBLEM ANALYSIS
2.CUSTOMER PROBLEM ANALYSIS

Result:
Proceed to
NEXT



NEXT

3.INSPECT BATTERY VOLTAGE
3.INSPECT BATTERY VOLTAGE
a.

Measure the battery voltage with the ignition switch off.

Standard voltage:

11 to 14 V


If the voltage is below 11 V, recharge or replace the battery before proceeding to the next step.


Result:
Proceed to
NEXT



NEXT

4.CHECK COMMUNICATION FUNCTION OF CAN COMMUNICATION SYSTEM*
4.CHECK COMMUNICATION FUNCTION OF CAN COMMUNICATION SYSTEM*
a.

Use the GTS to check if the CAN communication system is functioning normally.

Click herePower Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM(for LHD)>DIAGNOSTIC TROUBLE CODE CHART


Result:
Proceed to
CAN DTC is not output
CAN DTC is output



CAN DTC is not output

5.CHECK FOR DTC*

CAN DTC is output

5.CHECK FOR DTC*
a.

Check for DTCs and note any codes that are output.

Body Electrical > Driver Seat > Trouble Codes
50001 162

b.

Clear the DTCs.

Body Electrical > Driver Seat > Clear DTCs
50002 162

c.

Recheck for DTCs.

Body Electrical > Driver Seat > Trouble Codes
50001 162

Result:
Proceed to
DTC is not output
DTC is output



DTC is not output

6.PROBLEM SYMPTOMS TABLE

DTC is output

6.PROBLEM SYMPTOMS TABLE

Result:
Proceed to
Fault is not listed in problem symptoms table
Fault is listed in problem symptoms table



Fault is not listed in problem symptoms table

7.OVERALL ANALYSIS AND TROUBLESHOOTING*

Fault is listed in problem symptoms table

8.REPAIR OR REPLACE
7.OVERALL ANALYSIS AND TROUBLESHOOTING*

NEXT

8.REPAIR OR REPLACE
8.REPAIR OR REPLACE
Result:
Proceed to
NEXT



NEXT

9.CONFIRMATION TEST
9.CONFIRMATION TEST
Result:
Proceed to
NEXT



NEXT

END