| Part Tightened | N*m | kgf*cm | ft.*lbf | |||
|---|---|---|---|---|---|---|
| Front suspension member reinforcement RH x Front crossmember sub-assembly | 99 | 1010 | 73 | |||
| Front suspension member reinforcement RH x Front suspension member sub-assembly | 99 | 1010 | 73 | |||
| Part Tightened | N*m | kgf*cm | ft.*lbf | |||
|---|---|---|---|---|---|---|
| No. 1 camshaft bearing cap x Cylinder head sub-assembly | 21 | 214 | 15 | |||
| No. 3 camshaft bearing cap x Cylinder head sub-assembly | 10 | 102 | 7 | |||
| Oil pipe seat x No. 1 camshaft bearing cap | 17 | 173 | 13 | |||
| Part Tightened | N*m | kgf*cm | ft.*lbf | |||
|---|---|---|---|---|---|---|
| Cylinder head sub-assembly x Cylinder block sub-assembly
(New bolt) |
1st | 50 | 510 | 37 | ||
| 2nd | Tighten 90° | |||||
| 3rd | Tighten 90° | |||||
| 4th | Tighten 90° | |||||
| 5th | Loosen 90° | |||||
| 6th | Loosen 90° | |||||
| 7th | Tighten 90° | |||||
| 8th | Tighten 90° | |||||
| 9th | Tighten 90° | |||||
| Cylinder head sub-assembly x Cylinder block sub-assembly
(Used bolt) |
1st | 50 | 510 | 37 | ||
| 2nd | Tighten 90° | |||||
| 3rd | Tighten 90° | |||||
| 4th | Tighten 90° | |||||
| Part Tightened | N*m | kgf*cm | ft.*lbf | |||
|---|---|---|---|---|---|---|
| Crankshaft pulley x Crankshaft | 300 | 3059 | 221 | |||
| Part Tightened | N*m | kgf*cm | ft.*lbf | in.*lbf | |||
|---|---|---|---|---|---|---|---|
| Engine mounting insulator sub-assembly RH x Body | 95 | 969 | 70 | ||||
| Engine mounting insulator LH x Body | 95 | 969 | 70 | ||||
| Rear engine mounting insulator x Front crossmember sub-assembly | 95 | 969 | 70 | ||||
| Drive plate and ring gear sub-assembly x Crankshaft | 92 | 938 | 68 | ||||
| Stiffener plate LH x Cylinder block sub-assembly | 46 | 469 | 34 | ||||
| Stiffener plate LH x Manual transaxle | 46 | 469 | 34 | ||||
| Stiffener plate RH x Cylinder block sub-assembly | 46 | 469 | 34 | ||||
| Stiffener plate RH x Manual transaxle | 46 | 469 | 34 | ||||
| Oil pan insulator x Stiffner plate | 9.0 | 92 | 80 | ||||
| Engine mounting bracket LH x Body | 64 | 653 | 47 | ||||
| Rear engine mounting bracket x Manual transaxle | 45 | 459 | 33 | ||||
| Front engine mounting bracket x Manual transaxle | 64 | 653 | 47 | ||||
| No. 1 air tube x Manual transaxle | for bolt | 24 | 245 | 18 | |||
| for clamp | 6.5 | 66 | 58 | ||||
| Engine mounting insulator LH x Engine mounting bracket sub-assembly LH | 56 | 571 | 41 | ||||
| Engine mounting insulator sub-assembly RH x Engine mounting bracket RH | for bolt and nut A | 95 | 969 | 70 | |||
| for nut B | 52 | 530 | 38 | ||||
| Front suspension member sub-assembly x Body | for bolt A | 137 | 1397 | 101 | |||
| for bolt B | 93 | 948 | 69 | ||||
| Front crossmember sub-assembly x Body | 99 | 1010 | 73 | ||||
| Front crossmember sub-assembly x Front engine mounting insulator | 95 | 969 | 70 | ||||
| Rear engine mounting insulator x Rear engine mounting bracket | 95 | 969 | 70 | ||||
| Front engine mounting insulator x Front crossmember sub-assembly | 145 | 1479 | 107 | ||||
| Fuel hose protector x Cylinder head sub-assembly | 40 | 408 | 30 | ||||
| Front suspension member reinforcement LH x Front crossmember sub-assembly | 99 | 1010 | 73 | ||||
| Front suspension member reinforcement LH x Front suspension member sub-assembly | 99 | 1010 | 73 | ||||
| Drive plate and ring gear sub-assembly x Torque converter assembly | 44 | 449 | 32 | ||||
| Transmission control cable x Automatic transaxle assembly | 12 | 122 | 9 | ||||
| Suction hose sub-assembly x Cooler compressor assembly | 9.8 | 100 | 87 | ||||
| Discharge hose sub-assembly x Cooler compressor assembly | 9.8 | 100 | 87 | ||||
| Radiator reservoir assembly x Bracket | 5.0 | 51 | 44 | ||||
| Injector driver assembly x Body | 8.0 | 82 | 71 | ||||
| Ground cable x Automatic transaxle | 19 | 194 | 14 | ||||
| Wire harness clamp bracket x Body | 7.7 | 79 | 68 | ||||
| Starter wire x Starter assembly | 9.8 | 100 | 87 | ||||
| Engine wire cover clamp x Bracket | 7.7 | 79 | 68 | ||||
| Engine wire harness x No. 1 engine room relay block | 13 | 133 | 10 | ||||
| Air cleaner bracket x Body | 7.5 | 76 | 66 | ||||
| Fuel filter assembly x Air cleaner bracket | 7.0 | 71 | 62 | ||||
| Air cleaner support x Air cleaner bracket | 7.0 | 71 | 62 | ||||
| Air cleaner case x Air cleaner bracket | 5.0 | 51 | 44 | ||||
| Battery bracket reinforcement x Body | 20 | 204 | 15 | ||||
| Front battery bracket x Body | 20 | 204 | 15 | ||||
| Battery clamp x Body | for bolt | 17 | 173 | 13 | |||
| for nut | 4.9 | 50 | 43 | ||||
| Part Tightened | N*m | kgf*cm | ft.*lbf | in.*lbf | |||
|---|---|---|---|---|---|---|---|
| Cylinder block drain cock sub-assembly x Cylinder block sub-assembly | 25 | 255 | 18 | ||||
| Engine blancer assembly x Cylinder block sub-assembly | 50 | 510 | 37 | ||||
| Oil baffle plate x Cylinder block sub-assembly | 9.0 | 92 | 80 | ||||
| Camshaft timing sprocket x No. 2 camshaft | 20 | 204 | 15 | ||||
| No. 1 chain vibration damper x Cylinder block sub-assembly | 21 | 214 | 15 | ||||
| No. 1 chain tensioner assembly x Cylinder block sub-assembly | 9.0 | 92 | 80 | ||||
| Engine oil level sensor x No. 2 Oil pan sub-assembly | 7.0 | 71 | 62 | ||||
| Crankshaft position sensor x Cylinder block sub-assembly | 8.8 | 90 | 78 | ||||
| Camshaft position sensor x Timing chain cover sub-assembly | 8.8 | 90 | 78 | ||||
| Drive shaft bearing bracket x Cylinder block sub-assembly | 63.7 | 650 | 47 | ||||
| Fuel supply pump assembly x Cylinder head sub-assembly | 20.5 | 209 | 15 | ||||
| Glow plug assembly x Cylinder head sub-assembly | 12.3 | 125 | 9 | ||||
| No. 1 glow plug connector x Glow plug assembly | 2.2 | 22 | 19 | ||||
| Compressor stay x Cylinder block sub-assembly | 35 | 357 | 26 | ||||
| Part Tightened | N*m | kgf*cm | ft.*lbf | in.*lbf | |||
|---|---|---|---|---|---|---|---|
| Stud bolt x Cylinder head sub-assembly | for stud bolt A and B | 12 | 122 | 9 | |||
| for stud bolt C | 8.0 | 82 | 71 | ||||
| for stud bolt D | 5.0 | 51 | 44 | ||||
| No. 1 straight screw plug with head x Cylinder head sub-assembly | 25 | 255 | 18 | ||||
| Part Tightened | N*m | kgf*cm | ft.*lbf | in.*lbf | |||
|---|---|---|---|---|---|---|---|
| Stud bolt x Cylinder block sub-assembly | for stud bolt A | 20 | 204 | 15 | |||
| for stud bolt B and C | 3.0 | 31 | 27 | ||||
| for stud bolt C | 2.0 | 20 | 18 | ||||
| Stud bolt x Crankshaft bearing cap | 5.0 | 51 | 44 | ||||
| Oil reflector plate x Cylinder block sub-assembly | 9.0 | 92 | 80 | ||||
| No. 1 oil nozzle sub-assembly x Cylinder block sub-assembly | 9.0 | 92 | 80 | ||||
| No. 1 crankshaft position sensor plate x Crankshaft | 10.5 | 107 | 8 | ||||
| Crankshaft bearing cap x Cylinder block sub-assembly | 1st | 60 | 612 | 44 | |||
| 2nd | Tighten 90° | ||||||
| Crankshaft bearing cap x Cylinder block sub-assembly | 18 | 184 | 13 | ||||
| Connecting rod cap x Connecting rod sub-assembly | 1st | 40 | 408 | 30 | |||
| 2nd | Tighten 90° | ||||||