Home › Engine / Hybrid System › 1AD-FTV STARTING › STARTER(w/ Stop And Start System) › 2013.11–2015.10
RM3090E _51 Engine / Hybrid System _008740 1AD-FTV STARTING _0103788 STARTER(w/ Stop And Start System) A

1AD-FTV STARTING  STARTER(w/ Stop And Start System)  DISASSEMBLY  


PROCEDURE

Hide 28226A 1.REMOVE STARTER MAGNETIC SWITCH ASSEMBLY

a.
A297117

Remove the nut, and disconnect the lead wire from the starter magnetic switch assembly.


b.
A297118

Remove the 2 nuts and starter magnetic switch assembly.


Hide 28110 2.REMOVE STARTER DRIVE HOUSING ASSEMBLY

a.
A297119

Using a T30 "TORX" socket wrench, remove the 2 through bolts.


b.

Pull out the starter yoke assembly, the starter commutator end frame assembly and starter center bearing clutch sub-assembly together with the starter armature assembly.


c.

Remove the starter pinion drive lever.


Hide 28130 3.REMOVE STARTER COMMUTATOR END FRAME ASSEMBLY

a.
A297173

Remove the 2 screws and starter commutator end frame assembly.

NOTICE:

While holding down the lead wire, remove the starter commutator end frame assembly.



Hide 28160 4.REMOVE STARTER ARMATURE ASSEMBLY

a.
A297174

Using a screwdriver, hold the spring back and disconnect the brush from the starter brush holder assembly.


b.

Disconnect the 4 brushes, and remove the starter brush holder assembly.


c.
A165174

Remove the starter armature assembly from the starter yoke assembly.


Hide 28177 5.REMOVE STARTER ARMATURE PLATE

a.
A294292

Remove the starter armature plate from the starter center bearing clutch sub-assembly.


Hide 28255 6.REMOVE PLANETARY GEAR

a.
A291384

Remove the 3 planetary gears.