1. PRECAUTION
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION
12611
3.REMOVE NO. 1 ENGINE COVER
51441
4.REMOVE NO. 1 ENGINE UNDER COVER
5.DISCONNECT CABLE FROM POSITIVE BATTERY TERMINAL
74404A
6.REMOVE BATTERY CLAMP SUB-ASSEMBLY
28899
7.REMOVE BATTERY INSULATOR
28800
8.REMOVE BATTERY
74431
9.REMOVE BATTERY TRAY
74417
10.REMOVE FRONT BATTERY BRACKET
74414B
11.REMOVE BATTERY BRACKET REINFORCEMENT
17705
12.REMOVE AIR CLEANER CAP SUB-ASSEMBLY
17801
13.REMOVE AIR CLEANER FILTER ELEMENT SUB-ASSEMBLY
14.REMOVE AIR CLEANER CASE
17769
15.REMOVE AIR CLEANER SUPPORT
16.DISCONNECT FUEL FILTER ASSEMBLY
Remove the bolt and disconnect the fuel filter assembly.
17119A
17.REMOVE AIR CLEANER BRACKET
17361J
18.REMOVE NO. 1 AIR TUBE
Remove the bolt and detach the wire harness clamp.
Detach the 2 wire harness clamps.
Remove the 2 bolts and loosen the 2 clamps.
Remove the No. 1 air tube.
17343D
19.REMOVE NO. 3 AIR HOSE
28100
20.REMOVE STARTER ASSEMBLY
Disconnect the starter connector.
Open the terminal cap, remove the nut and disconnect the starter wire.
Remove the 2 bolts and starter assembly.