Home › Engine / Hybrid System › 1AD-FTV STARTING › STARTER(w/o Stop And Start System) › 2013.11–2015.10
RM3090E _51 Engine / Hybrid System _008740 1AD-FTV STARTING _0103789 STARTER(w/o Stop And Start System) A

1AD-FTV STARTING  STARTER(w/o Stop And Start System)  DISASSEMBLY  


PROCEDURE

Hide 28226B 1.REMOVE MAGNET STARTER SWITCH ASSEMBLY

a.
A301842

Remove the nut and disconnect the lead wire from the magnet starter switch assembly.


b.
A298941

Remove the 2 nuts from the starter drive housing assembly while holding the magnet starter switch assembly.


c.
A298942

Pull the magnet starter switch assembly and, while lifting the front part of the magnet starter switch assembly, release the plunger hook from the starter pinion drive lever and remove the magnet starter switch assembly.


Hide 28120 2.REMOVE STARTER YOKE ASSEMBLY

a.
A298943

Using a T25 "TORX" socket wrench, remove the 2 through bolts.


b.
A298944

Pull out the starter yoke assembly together with the starter commutator end frame assembly.


c.
A298945

Remove the 2 screws and starter commutator end frame assembly from the starter yoke assembly.

NOTICE:
A298946
1.385,0.417 1.667,0.198 1.667,0.198 1.906,0.198 false 1.948,0.104 2.26,0.26 0.313,0.156 10 false *a
*a Lead Wire


While holding down the lead wire, remove the starter commutator end frame assembly.



Hide 28140 3.REMOVE STARTER BRUSH HOLDER ASSEMBLY

a.
A215969

Using a screwdriver, pry the end of the spring away from each brush and pull out the 4 brushes from the starter brush holder assembly so that they are held in place by the springs.


b.

Remove the starter brush holder assembly.


Hide 28160 4.REMOVE STARTER ARMATURE ASSEMBLY

a.
A290033

Remove the starter armature assembly from the starter yoke assembly.


Hide 28021 5.REMOVE STARTER CENTER BEARING CLUTCH SUB-ASSEMBLY

a.
A298947

Remove the starter armature plate from the starter center bearing clutch sub-assembly or starter yoke assembly.


b.
A298948

Remove the 3 planetary gears from the starter center bearing clutch sub-assembly.


c.
A298949
2.438,0.25 2.594,0.25 2.594,0.25 2.948,0.865 false 1.135,0.302 1.365,0.302 1.365,0.302 1.917,0.521 false 1.625,3.083 1.792,3.083 1.792,3.083 2.063,2.792 false 0.99,0.219 1.302,0.375 0.313,0.156 10 false *1 2.271,0.156 2.583,0.313 0.313,0.156 10 false *2 1.469,2.99 1.781,3.146 0.313,0.156 10 false *3
*1 Starter Pinion Drive Lever
*2 Rubber Seal
*3 Starter Center Bearing Clutch Sub-assembly


Remove the starter center bearing clutch sub-assembly together with the starter pinion drive lever and rubber seal from the starter drive housing assembly.


d.

Remove the starter pinion drive lever and rubber seal from the starter center bearing clutch sub-assembly.