Home › Engine / Hybrid System › CRUISE CONTROL › LANE RECOGNITION CAMERA SENSOR › 2013.11–2015.10
RM3090E _51 Engine / Hybrid System _008749 CRUISE CONTROL _0050654 LANE RECOGNITION CAMERA SENSOR A

CRUISE CONTROL  LANE RECOGNITION CAMERA SENSOR  REMOVAL  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for RHD and LHD vehicles.

·

The procedure listed below is for LHD vehicles.



PROCEDURE

Hide 89943 1.REMOVE RAIN SENSOR COVER

a.
B338906

Detach the 2 claws and remove the rain sensor cover as shown in the illustration.


Hide 87810 2.REMOVE INNER REAR VIEW MIRROR ASSEMBLY

Hide 86466 3.REMOVE LANE DEPARTURE WARNING CAMERA COVER NO.1

a.
B338907

Pull the lane departure warning camera cover in the direction indicated by the arrow to detach the 4 guides and remove the lane departure warning camera cover as shown in the illustration.


Hide 86468 4.REMOVE LANE DEPARTURE WARNING CAMERA

a.
B338908N01
2.135,4.167 2.417,4.385 0.281,0.219 10 (2) 1.135,4.323 1.417,4.542 0.281,0.219 10 (1)

Disconnect the connector.


b.

Detach the 3 guides and remove the lane departure warning camera as shown in the illustration.

NOTICE:
·

Do not pull the harness forcibly when disconnecting the connector.

·

If the lane departure warning camera bracket is deformed or damaged, replace it together with the windshield glass.

·

If the windshield glass is replaced on a vehicle equipped with an lane departure alert camera, make sure to use a Toyota genuine part, as the camera may not be able to be installed due to a missing bracket or the lane departure alert system may not operate properly due to a difference in the transmissivity or ceramic line shape.

·

If the lane departure warning camera is dropped, replace it with a new one.