Home › Engine / Hybrid System › CRUISE CONTROL › LANE RECOGNITION CAMERA SENSOR › 2013.11–2015.10
RM3090E _51 Engine / Hybrid System _008749 CRUISE CONTROL _0050654 LANE RECOGNITION CAMERA SENSOR A

CRUISE CONTROL  LANE RECOGNITION CAMERA SENSOR  INSTALLATION  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for RHD and LHD vehicles.

·

The procedure listed below is for LHD vehicles.



CAUTION / NOTICE / HINT

NOTICE:
·

If the lane departure warning camera bracket is deformed or damaged, replace it together with the windshield glass.

·

If the windshield glass is replaced on a vehicle equipped with an lane departure alert camera, make sure to use a Toyota genuine part, as the camera may not be able to be installed due to a missing bracket or the lane departure alert system may not operate properly due to a difference in the transmissivity or ceramic line shape.

·

If the lane departure warning camera is dropped, replace it with a new one.



PROCEDURE

Hide 86468 1.INSTALL LANE DEPARTURE WARNING CAMERA

a.

When using a new lane departure warning camera:

i.
B338909

Remove the protective film.

NOTICE:

Do not touch the camera lens after removing the protective film.




b.

Attach the 2 guides as shown in the illustration.

B338910N01
0.135,1.813 7.042,4.75 6.906,2.938 0.146,3.813 0.448,4 0.302,0.188 10 10° 4.083,1.542 4.313,1.729 0.229,0.188 10 (2) 4.844,1.219 5.073,1.406 0.229,0.188 10 (1)

NOTICE:

Do not touch the camera lens.



c.

Attach the guide as shown in the illustration.


d.

Connect the connector and install the lane departure warning camera.


Hide 86466 2.INSTALL LANE DEPARTURE WARNING CAMERA COVER NO.1

a.

Attach the 4 guides and install the lane departure warning camera cover as shown in the illustration.

B338911


Hide 86466 3.INSPECT LANE DEPARTURE WARNING CAMERA COVER NO.1

a.
B338912N01
0.729,1.948 0.552,1.833 0.552,1.833 0.427,1.833 true 0.271,1.74 0.49,1.948 0.219,0.208 10 A

Check the clearance of area A.

Standard Clearance
Area Measurement
A 0 to 2 mm (0 to 0.0787 in.)

HINT:

If the result is not as specified, the guides are not attached properly. Reinstall the lane departure warning camera cover.



Hide 87810 4.INSTALL INNER REAR VIEW MIRROR ASSEMBLY

Hide 89943 5.INSTALL RAIN SENSOR COVER

a.

Attach the 2 claws to install the rain sensor cover.


Hide 86468 6.ADJUST LANE DEPARTURE WARNING CAMERA