Home › Engine / Hybrid System › CRUISE CONTROL › LANE DEPARTURE ALERT SWITCH(for LHD) › 2013.11–2015.10
RM3090E _51 Engine / Hybrid System _008749 CRUISE CONTROL _0104314 LANE DEPARTURE ALERT SWITCH(for LHD) A

CRUISE CONTROL  LANE DEPARTURE ALERT SWITCH(for LHD)  REMOVAL  


PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION


Hide 55412C 3.REMOVE CENTER NO. 1 INSTRUMENT CLUSTER FINISH PANEL

Hide 83950M 4.REMOVE TELLTALE LIGHT ASSEMBLY (LANE DEPARTURE ALERT SWITCH)

a.
B337767

Detach the 2 clips and claw.


b.
B337768

Disconnect the connector to remove the telltale light assembly (lane departure alert switch).