Home › Engine / Hybrid System › CRUISE CONTROL › LANE DEPARTURE ALERT SWITCH(for RHD) › 2013.11–2015.10
RM3090E _51 Engine / Hybrid System _008749 CRUISE CONTROL _0104315 LANE DEPARTURE ALERT SWITCH(for RHD) G

CRUISE CONTROL  LANE DEPARTURE ALERT SWITCH(for RHD)  INSPECTION  


PROCEDURE

Hide 84978 1.INSPECT LANE-KEEPING ASSIST MAIN SWITCH (LANE DEPARTURE ALERT SWITCH)

a.
B357149C01
2.042,1.177 2.552,0.51 true 1.427,1.167 0.906,0.521 true 2.125,1.698 1.875,1.26 true 1.427,1.698 1.604,1.271 true 0,0 0.313,0.156 0.313,0.156 10 false *a 0.563,0.448 1.021,0.646 0.458,0.198 10 false ECU 2.583,0.417 3.042,0.615 0.458,0.198 10 false GND 1.302,1.729 1.76,1.927 0.458,0.198 10 false ILL+ 2.083,1.74 2.542,1.938 0.458,0.198 10 false ILL-
*a Component without harness connected
(Lane-keeping Assist Main Switch (lane departure alert switch))


Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
3(GND) - 6(ECU) Lane-keeping assist main switch (lane departure alert switch) pushed Below 1 Ω
3(GND) - 6(ECU) Lane-keeping assist main switch (lane departure alert switch) not pushed 10 kΩ or higher


If the result is not as specified, replace the lane-keeping assist main switch (lane departure alert switch).


b.

Inspect the illumination operation.

i.

Apply battery voltage to the lane-keeping assist main switch connector, and check that the lane-keeping assist main switch (lane departure alert switch) illuminates.

OK:
Measurement Condition Specified Condition
Battery positive (+) → Terminal 5(ILL+)
Battery negative (-) → Terminal 4(ILL-)
Illuminates


If the result is not as specified, replace the lane-keeping assist main switch (lane departure alert switch).