86652A
1.INSTALL SKID CONTROL BUZZER ASSEMBLY (LANE DEPARTURE ALERT BUZZER)
Connect the connector.
Attach the clamp to install the skid control buzzer assembly (lane departure alert buzzer).
55870B
2.INSTALL HEATER TO REGISTER DUCT ASSEMBLY
55950G
3.INSTALL DEFROSTER NOZZLE ASSEMBLY
4.INSTALL UPPER INSTRUMENT PANEL
5.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION
6.CHECK SRS WARNING LIGHT