Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › PARKING ASSIST MONITOR SYSTEM(for Camera built-in ECU) › from 2013.11
RM3090E _56 Audio / Visual / Telematics _008432 PARK ASSIST / MONITORING _0103549 PARKING ASSIST MONITOR SYSTEM(for Camera built-in ECU) U

PARK ASSIST / MONITORING  PARKING ASSIST MONITOR SYSTEM(for Camera built-in ECU)  DATA LIST / ACTIVE TEST  


DATA LIST


NOTICE:

In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.


HINT:

Using the GTS to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.


a.

Connect the GTS to the DLC3.


b.

Turn the ignition switch to ON.


c.

Turn the GTS on.


d.

Enter the following menus: Chassis / Parking Assist Monitor / Data List.


e.

Enter the following menus: Body Electrical / Main Body / Data List.


f.

Read the Data List according to the display on the GTS.

Chassis > IPA/Parking Assist Monitor > Data List
Tester Display Measurement Item Range Normal Condition Diagnostic Note
EEPROM Status (Initial read) Television camera assembly information OK or NG OK: Television camera assembly is normal
NG: Television camera assembly is abnormal
-
CPU Communication Status Status of the CPU Communication Check OK or NG OK: Status of the CPU communication is normal
NG: Status of the CPU communication is abnormal
-
ASIC Output Status Output condition of camera display signal OK or NG OK: Output condition of camera display signal is normal
NG: Output condition of camera display signal is abnormal
If "NG" is displayed, there is a malfunction in the television camera assembly.
Wheel Speed Sensor (4wheel) Status of the Wheel Speed Sensor (4 wheel) Check OK or NG OK: Status of the Wheel Speed Sensor (4 wheel) is normal
NG: Status of the Wheel Speed Sensor (4 wheel) is abnormal
-
Parking Assist Function of Camera Status of the parking assist function of camera Valid or Invalid Valid: Status of the parking assist function of camera is vaild
Invalid: Status of the parking assist function of camera is invalid
-
Number of DTC Number of trouble codes Min.: 0
Max.: 255
Number of DTCs displayed -
Body Electrical > Main Body > Data List
Tester Display Measurement Item Range Normal Condition Diagnostic Note
Back Door Courtesy SW Back door courtesy switch signal ON or OFF ON: Back door open
OFF: Back door closed
-