Home › Audio / Visual / Telematics › AUDIO / VIDEO › AUDIO AND VISUAL SYSTEM(for Radio and Display Type) › 2013.11–2016.08
RM3090E _56 Audio / Visual / Telematics _008775 AUDIO / VIDEO _0048748 AUDIO AND VISUAL SYSTEM(for Radio and Display Type) J

AUDIO / VIDEO  AUDIO AND VISUAL SYSTEM(for Radio and Display Type)  Voice Guidance Circuit between Radio Receiver and Stereo Component Amplifier  


DESCRIPTION

This circuit is used when the voice switch of the steering pad switch assembly is pushed.

Using this circuit, the radio and display receiver assembly sends signals to the stereo component amplifier assembly.

WIRING DIAGRAM

E271821E03
0.198,2.677 0.656,2.875 0.458,0.198 10 false M32 0.198,2.854 1.438,3.271 1.24,0.417 10 false Stereo Component Amplifier Assembly 2.063,2.521 3.135,2.719 1.073,0.198 10 false Shielded 3.292,2.521 3.875,2.75 0.583,0.229 10 false Shielded 5.656,2.844 6.885,3.229 1.229,0.385 10 false Radio and Display Receiver Assembly 5.656,2.677 6.094,2.917 0.438,0.24 10 false G142 5.958,0.792 6.573,0.99 0.615,0.198 10 false RL+ 5.708,0.667 5.948,0.865 0.24,0.198 10 false 2 5.969,1.583 6.583,1.781 0.615,0.198 10 false RL- 5.708,1.469 5.948,1.667 0.24,0.198 10 false 6 0.865,2.365 1.479,2.563 0.615,0.198 10 false SLD1 1.323,2.24 1.635,2.438 0.313,0.198 10 false 18 0.979,0.76 1.281,0.979 0.302,0.219 10 false II1+ 1.01,1.563 1.302,1.75 0.292,0.188 10 false II1- 1.323,0.667 1.635,0.865 0.313,0.198 10 false 15 1.344,1.479 1.656,1.677 0.313,0.198 10 false 14

PROCEDURE

1.CHECK HARNESS AND CONNECTOR (RADIO AND DISPLAY RECEIVER ASSEMBLY - STEREO COMPONENT AMPLIFIER ASSEMBLY)
a.

Disconnect the G142 radio and display receiver assembly connector.


b.

Disconnect the M32 stereo component amplifier assembly connector.


c.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
G142-2 (RL+) - M32-15 (II1+) Always Below 1 Ω
G142-6 (RL-) - M32-14 (II1-) Always Below 1 Ω
M32-18 (SLD1) - Body ground Always 10 kΩ or higher
G142-2 (RL+) - Body ground Always 10 kΩ or higher
G142-6 (RL-) - Body ground Always 10 kΩ or higher



Result:
Proceed to
OK
NG



OK

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR