Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › PARKING ASSIST MONITOR SYSTEM(for Navigation Receiver Type) › 2013.11–2014.10
RM3090E _56 Audio / Visual / Telematics _008432 PARK ASSIST / MONITORING _0103548 PARKING ASSIST MONITOR SYSTEM(for Navigation Receiver Type) C

PARK ASSIST / MONITORING  PARKING ASSIST MONITOR SYSTEM(for Navigation Receiver Type)  C1626  Steering Angle Sensor Failure  


DESCRIPTION

This DTC is stored if the navigation ECU sub-assembly receives a signal via CAN communication from the spiral with sensor cable sub-assembly that indicates an internal malfunction.

DTC No. Detection Item DTC Detection Condition Trouble Area
C1626 Steering Angle Sensor Failure A fail flag is transmitted from the spiral with sensor cable sub-assembly.
·

Spiral with sensor cable sub-assembly

·

Navigation ECU sub-assembly



CAUTION / NOTICE / HINT

NOTICE:
·

When "System initializing" is displayed on the navigation ECU sub-assembly after disconnecting the cable from the negative (-) battery terminal, correct the steering angle neutral point (Click here Audio / Visual / Telematics>PARK ASSIST / MONITORING>PARKING ASSIST MONITOR SYSTEM(for Navigation Receiver Type)>INITIALIZATION).

·

Depending on the parts that are replaced or operations that are performed during vehicle inspection or maintenance, calibration of other systems as well as the parking assist monitor system may be needed (Click here Audio / Visual / Telematics>PARK ASSIST / MONITORING>PARKING ASSIST MONITOR SYSTEM(for Navigation Receiver Type)>CALIBRATION).



PROCEDURE

1.REPLACE SPIRAL WITH SENSOR CABLE SUB-ASSEMBLY
a.

Replace the spiral with sensor cable sub-assembly.

Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>SPIRAL CABLE(for Single Type)>REMOVAL


Result:
Proceed to
NEXT



NEXT

2.CHECK DTC
2.CHECK DTC

DTC C1626 is not output

END (SPIRAL WITH SENSOR CABLE SUB-ASSEMBLY IS DEFECTIVE)

DTC C1626 is output