Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › PARKING ASSIST MONITOR SYSTEM(for Navigation Receiver Type) › 2013.11–2014.10
RM3090E _56 Audio / Visual / Telematics _008432 PARK ASSIST / MONITORING _0103548 PARKING ASSIST MONITOR SYSTEM(for Navigation Receiver Type) C

PARK ASSIST / MONITORING  PARKING ASSIST MONITOR SYSTEM(for Navigation Receiver Type)  C1691  Back Camera Initialization Incomplete  


DESCRIPTION

This DTC is stored when the navigation ECU sub-assembly judges that the back camera initial setting has not been memorized (television camera assembly optical axis adjustment (back camera position setting) is incomplete).

DTC No. Detection Item DTC Detection Condition Trouble Area
C1691 Back Camera Initialization Incomplete Back camera initial setting has not been memorized (rear television camera assembly optical axis adjustment (back camera position setting) is incomplete)
·

Television camera assembly optical axis adjustment (back camera position setting)

·

Navigation ECU sub-assembly



CAUTION / NOTICE / HINT

NOTICE:
·

When "System initializing" is displayed on the navigation ECU sub-assembly after disconnecting the cable from the negative (-) battery terminal, correct the steering angle neutral point (Click here Audio / Visual / Telematics>PARK ASSIST / MONITORING>PARKING ASSIST MONITOR SYSTEM(for Navigation Receiver Type)>INITIALIZATION).

·

Depending on the parts that are replaced or operations that are performed during vehicle inspection or maintenance, calibration of other systems as well as the parking assist monitor system may be needed (Click here Audio / Visual / Telematics>PARK ASSIST / MONITORING>PARKING ASSIST MONITOR SYSTEM(for Navigation Receiver Type)>CALIBRATION).



PROCEDURE

1.ADJUST SETTINGS (BACK CAMERA POSITION SETTING)
a.

Perform the following procedure depending on the memory conditions to register the vehicle information into the navigation ECU sub-assembly.

i.

Television camera assembly optical axis adjustment (back camera position setting) (Click here Audio / Visual / Telematics>PARK ASSIST / MONITORING>PARKING ASSIST MONITOR SYSTEM(for Navigation Receiver Type)>CALIBRATION).



Result:
Proceed to
NEXT



NEXT

2.CHECK DTC
2.CHECK DTC

b.

Check for DTCs (Click here Audio / Visual / Telematics>PARK ASSIST / MONITORING>PARKING ASSIST MONITOR SYSTEM(for Navigation Receiver Type)>DTC CHECK / CLEAR).

HINT:
·

If DTC C1691 is output, perform the television camera assembly optical axis adjustment (back camera position setting) again.

·

If DTC C1691 is still output after performing the television camera assembly optical axis adjustment 3 times, replace the navigation ECU sub-assembly.




Result:
Proceed to
DTC C1691 is not output
DTC C1691 is output.



DTC C1691 is not output

END

DTC C1691 is output.