Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › PARKING ASSIST MONITOR SYSTEM(for Navigation Receiver Type) › 2013.11–2014.10
RM3090E _56 Audio / Visual / Telematics _008432 PARK ASSIST / MONITORING _0103548 PARKING ASSIST MONITOR SYSTEM(for Navigation Receiver Type) C

PARK ASSIST / MONITORING  PARKING ASSIST MONITOR SYSTEM(for Navigation Receiver Type)  C1694  Steering Angle Initialization Incomplete  


DESCRIPTION

This DTC is stored when the navigation ECU sub-assembly judges that the maximum steering angle has not been memorized (steering angle setting is incomplete).


DTC No. Detection Item DTC Detection Condition Trouble Area
C1694 Steering Angle Initialization Incomplete Maximum steering angle has not been memorized (steering angle setting is incomplete)
·

Steering angle setting

·

Navigation ECU sub-assembly



CAUTION / NOTICE / HINT

NOTICE:
·

When "System initializing" is displayed on the navigation ECU sub-assembly after disconnecting the cable from the negative (-) battery terminal, correct the steering angle neutral point (Click here Audio / Visual / Telematics>PARK ASSIST / MONITORING>PARKING ASSIST MONITOR SYSTEM(for Navigation Receiver Type)>INITIALIZATION).

·

Depending on the parts that are replaced or operations that are performed during vehicle inspection or maintenance, calibration of other systems as well as the parking assist monitor system may be needed (Click here Audio / Visual / Telematics>PARK ASSIST / MONITORING>PARKING ASSIST MONITOR SYSTEM(for Navigation Receiver Type)>CALIBRATION).



PROCEDURE

1.ADJUST SETTINGS (STEERING ANGLE SETTING)

Result:
Proceed to
NEXT



NEXT

2.CHECK DTC
2.CHECK DTC

b.

Check for DTCs (Click here Audio / Visual / Telematics>PARK ASSIST / MONITORING>PARKING ASSIST MONITOR SYSTEM(for Navigation Receiver Type)>DTC CHECK / CLEAR).

OK:

DTC C1694 is not output.


HINT:
·

If DTC C1694 is output, perform the steering angle setting again.

·

If DTC C1694 is still output after performing the steering angle setting 3 times, replace the navigation ECU sub-assembly.




Result:
Proceed to
DTC C1694 is not output
DTC C1694 is output



DTC C1694 is not output

END

DTC C1694 is output