Home › Audio / Visual / Telematics › NAVIGATION / MULTI INFO DISPLAY › NAVIGATION SYSTEM(for SD) › from 2013.11
RM3090E _56 Audio / Visual / Telematics _008776 NAVIGATION / MULTI INFO DISPLAY _0104513 NAVIGATION SYSTEM(for SD) C

NAVIGATION / MULTI INFO DISPLAY  NAVIGATION SYSTEM(for SD)  B1550  DAB Tuner Malfunction  B15A0  LAN Master Malfunction  B15AD  Navigation Processor Malfunction  B15B0  Display Screen Malfunction  B15B3  Radio Tuner Malfunction  B15B4  CD Changer Malfunction  B15B7  Bluetooth Module Malfunction  


DESCRIPTION

These DTCs are stored when a malfunction occurs in the navigation receiver assembly.

DTC No. Detection Item DTC Detection Condition Trouble Area
B1550 DAB Tuner Malfunction Digital radio tuner has a malfunction Navigation receiver assembly
B15A0 LAN Master Malfunction When one of the conditions below is met:
·

Bus malfunction

·

EEPROM error


Navigation receiver assembly
B15AD Navigation Processor Malfunction When one of the conditions below is met:
·

Short to ground or +B, or open occurs in gyro signal circuit

·

Gyro sensor malfunction

·

GPS receiver malfunction


Navigation receiver assembly
B15B0 Display Screen Malfunction Picture circuit (TFT unit) malfunction Navigation receiver assembly
B15B3 Radio Tuner Malfunction When one of the conditions below is met:
·

AM tuner PLL is unlocked

·

FM tuner PLL is unlocked

·

Tuner malfunction


Navigation receiver assembly
B15B4 CD Changer Malfunction When one of the conditions below is met:
·

Mechanical communication error

·

Load/Eject malfunction

·

Read malfunction

·

Mechanical malfunction


Navigation receiver assembly
B15B7 Bluetooth Module Malfunction "Bluetooth" module malfunction Navigation receiver assembly

CAUTION / NOTICE / HINT

NOTICE:

Check that the wire harness is properly installed and does not have any sharp bends, pinching or loose connections.

Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING


PROCEDURE

1.CHECK FOR DTC
a.

Clear the DTCs.

Click hereAudio / Visual / Telematics>NAVIGATION / MULTI INFO DISPLAY>NAVIGATION SYSTEM(for SD)>DTC CHECK / CLEAR

Body Electrical > Navigation System > Clear DTCs
50002 212

b.

Recheck for DTCs and check that no DTCs are output.

Click hereAudio / Visual / Telematics>NAVIGATION / MULTI INFO DISPLAY>NAVIGATION SYSTEM(for SD)>DTC CHECK / CLEAR

Body Electrical > Navigation System > Trouble Codes
50001 212
OK:

No DTCs are output.



Result:
Proceed to
OK
NG



OK

NG