The No. 1 stereo jack adapter assembly sends the sound signal from an external device to the navigation receiver assembly via this circuit.
The sound signal that has been sent is amplified by the navigation receiver assembly, and then is sent to the speakers.
If there is an open or short in the circuit, sound cannot be heard from the speakers even if there is no malfunction in the navigation receiver assembly or speakers.
Check that the wire harness is properly installed and does not have any sharp bends, pinching or loose connections.
Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING
Disconnect the G139 navigation receiver assembly connector.
Disconnect the G145 No. 1 stereo jack adapter assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| G139-25 (ADPG) - G145-9 (AUXO) | Always | Below 1 Ω |
| G139-26 (VAR+) - G145-6 (ARO) | Always | Below 1 Ω |
| G139-28 (VAL+) - G145-7 (ALO) | Always | Below 1 Ω |
| G139-27 (VA-) - G145-8 (ASGN) | Always | Below 1 Ω |
| G139-11 (AGND) - G145-10 (AGND) | Always | Below 1 Ω |
| G139-25 (ADPG) - Body ground | Always | 10 kΩ or higher |
| G139-26 (VAR+) - Body ground | Always | 10 kΩ or higher |
| G139-28 (VAL+) - Body ground | Always | 10 kΩ or higher |
| G139-27 (VA-) - Body ground | Always | 10 kΩ or higher |
| G139-11 (AGND) - Body ground | Always | 10 kΩ or higher |
| Proceed to |
|---|
| OK |
| NG |
OK
NG