Home › Audio / Visual / Telematics › NAVIGATION / MULTI INFO DISPLAY › NAVIGATION SYSTEM(for SD) › 2013.11–2015.10
RM3090E _56 Audio / Visual / Telematics _008776 NAVIGATION / MULTI INFO DISPLAY _0104513 NAVIGATION SYSTEM(for SD) J

NAVIGATION / MULTI INFO DISPLAY  NAVIGATION SYSTEM(for SD)  Data Signal Circuit between Navigation Receiver Assembly and Stereo Jack Adapter  


DESCRIPTION

The No. 1 stereo jack adapter assembly sends the sound data signal or image data signal from a USB device to the navigation receiver assembly via this circuit.

WIRING DIAGRAM

E281004E03
2.073,0.615 2.229,0.813 0.156,0.198 10 false 2 2.073,1.198 2.229,1.396 0.156,0.198 10 false 3 4.958,0.625 5.115,0.823 0.156,0.198 10 false 2 4.969,1.167 5.125,1.365 0.156,0.198 10 false 3 5.167,1.833 5.719,2.042 0.552,0.208 10 false G149 5.177,2.01 6.427,2.385 1.25,0.375 10 false Navigation Receiver Assembly 0.969,1.813 1.521,2.021 0.552,0.208 10 false G145 0.979,2 2.229,2.375 1.25,0.375 10 false No. 1 Stereo Jack Adapter Assembly 1.604,0.781 2.156,0.99 0.552,0.208 10 false UDO- 1.604,1.313 2.156,1.521 0.552,0.208 10 false UDO+ 5.198,0.771 5.75,0.979 0.552,0.208 10 false UDO- 5.208,1.344 5.76,1.552 0.552,0.208 10 false UDO+

CAUTION / NOTICE / HINT

NOTICE:

Check that the wire harness is properly installed and does not have any sharp bends, pinching or loose connections.

Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING


PROCEDURE

1.CHECK HARNESS AND CONNECTOR (NAVIGATION RECEIVER ASSEMBLY - NO. 1 STEREO JACK ADAPTER ASSEMBLY)
a.

Disconnect the G149 navigation receiver assembly connector.


b.

Disconnect the G145 No. 1 stereo jack adapter assembly connector.


c.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
G149-2 (UDO-) - G145-2 (UDO-) Always Below 1 Ω
G149-3 (UDO+) - G145-3 (UDO+) Always Below 1 Ω
G149-2 (UDO-) - Body ground Always 10 kΩ or higher
G149-3 (UDO+) - Body ground Always 10 kΩ or higher



Result:
Proceed to
OK
NG



OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR