The display signal of the rear television camera assembly is transmitted to the navigation receiver assembly.
Disconnect the G158 navigation receiver assembly connector.
Disconnect the U6 rear television camera assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| G158-11 (CA+) - U6-6 (CB+) | Always | Below 1 Ω |
| G158-12 (V+) - U6-3 (CV+) | Always | Below 1 Ω |
| G158-24 (V-) - U6-2 (CV-) | Always | Below 1 Ω |
| G158-23 (CGND) - U6-5 (CGND) | Always | Below 1 Ω |
| G158-11 (CA+) - Body ground | Always | 10 kΩ or higher |
| G158-12 (V+) - Body ground | Always | 10 kΩ or higher |
| G158-24 (V-) - Body ground | Always | 10 kΩ or higher |
| G158-23 (CGND) - Body ground | Always | 10 kΩ or higher |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
| *a | Component with harness connected
(Navigation Receiver Assembly) |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| G158-23 (CGND) - Body ground | Always | Below 1 Ω |
| G158-24 (V-) - Body ground | Always | Below 1 Ω |
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
|---|---|---|
| G158-11 (CA+) - Body ground | Ignition switch ON | 5.5 to 7.05 V |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Check the waveform of the rear television camera assembly using an oscilloscope.
| *a | Component with harness connected
(Navigation Receiver Assembly) |
*b | Waveform 1 |
| *c | Waveform 2 | *d | Synchronized Signal |
| *e | Video Waveform | - | - |
A waterproof connector is used for the rear television camera assembly. Therefore, inspect the waveform at the navigation receiver assembly with the connector connected.
Waveform is as shown in the illustration.
| Item | Content |
|---|---|
| Terminal No. (Symbol) | G158-12 (V+) - G158-23 (CGND) |
| Tool Setting | 200 mV/DIV., 50 μsec./DIV. |
| Condition | Waveform 1: Ignition switch ON, camera lens is not covered, displaying an image
Waveform 2: Ignition switch ON, camera lens is covered, blacking out the screen |
The video waveform changes according to the image sent by the rear television camera assembly.
| Proceed to |
|---|
| OK |
| NG |
OK
NG