The navigation ECU sub-assembly receives a vehicle speed signal from the combination meter assembly and information from the navigation antenna assembly, and then adjusts the vehicle position.
The navigation ECU sub-assembly stores this DTC when the difference between the speed information that the navigation antenna assembly receives and the SPD pulse received from the combination mete rassembly becomes large.
A voltage of 12 V or 5 V is output from each ECU and then input to the combination meter assembly. The signal is changed to a pulse signal at the transistor in the combination meter assembly. Each ECU controls the respective systems based on the pulse signal.
If a short occurs in any of the ECUs or in the wire harness connected to an ECU, all systems in the diagram below will not operate normally.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| B15C2 | Speed Signal Malfunction | A difference between the GPS speed and SPD pulse is detected. | ·
Meter/gauge System ·
Harness or connector ·
Navigation ECU sub-assembly |
Enter "GPS & Vehicle Sensor" (Vehicle Sensors)
While driving the vehicle, compare the "SPD" indicator to the reading on the speedometer. Check if these readings are equal or almost equal.
| Proceed to |
|---|
| The readings are equal or almost equal |
| The readings are not equal or almost equal |
The readings are equal or almost equal
The readings are not equal or almost equal
| *a | Component with harness connected
(Combination Meter Assembly) |
Check the output waveform
Remove the combination meter assembly with theconnector(s) still connected.
Connect an oscilloscope to terminal G16-6 (+S) and body ground.
Turn the engine switch on (IG).
Turn a wheel slowly.
Check the signal waveform according to thecondition(s) in the table below.
| Item | Condition |
|---|---|
| Measurement terminal | G16-6 (+S) - Body ground |
| Tool setting | 5 V/DIV., 20 ms./DIV. |
| Vehicle condition | Wheel being rotated |
The waveform is similar to that shown in the illustration.
When the system is functioning normally, one wheelrevolution generates 4 pulses. As the vehicle speedincreases, the width indicated by A in the illustrationnarrows.
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Click hereVehicle Interior>METER / GAUGE / DISPLAY>METER / GAUGE SYSTEM>HOW TO PROCEED WITH TROUBLESHOOTING
Disconnect the G139 navigation ECU sub-assemblyconnector.
Disconnect the G16 combination meter assemblyconnector.
Measure the resistance according to the value(s) in thetable below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| G139-17 (SPD) - G16-6 (+S) | Always | Below 1 Ω |
| Proceed to |
|---|
| OK |
| NG |
OK
NG