When using a vise, place aluminum plates between the part and vise.
When using a vise, do not overtighten it.
1.INSPECT FRONT DRIVE SHAFT ASSEMBLY
Check that there is no excessive play in the radial direction of the outboard joint.
Check that the inboard joint slides smoothly in the thrust direction.
Check that there is no severe play in the radial direction of the inboard joint.
Check the 2 joint boots for damage.
| *A | for LH Side |
| *B | for RH Side |
Check that the 2 joint boots are not stretched or contracted when the front drive shaft is at the standard length.
| Item | Length | |
|---|---|---|
| for 2AD-FTV, 2AD-FHV (Automatic Transaxle) | LH Side | 565.6 mm (1.86 ft.) |
| RH Side | 928.4 mm (3.05 ft.) | |
| for 1AD-FTV, 2AD-FTV, 2AD-FHV (Manual Transaxle) | LH Side | 553.6 mm (1.82 ft.) |
| RH Side | 933.9 mm (3.06 ft.) | |
| for 2AR-FE (Automatic Transaxle) | LH Side | 577.6 mm (1.89 ft.) |
| RH Side | 922.4 mm (3.03 ft.) | |
| for 2AR-FE (Manual Transaxle) | LH Side | 583.6 mm (1.91 ft.) |
| RH Side | 909.4 mm (2.98 ft.) | |
| for 3ZR-FE, 3ZR-FAE (Manual Transaxle) | LH Side | 594.6 mm (1.95 ft.) |
| RH Side | 896.4 mm (2.94 ft.) | |
| for 3ZR-FE (CVT) | LH Side | 591.2 mm (1.94 ft.) |
| RH Side | 881.9 mm (2.89 ft.) | |
| for 3ZR-FAE (CVT) | LH Side | 591.2 mm (1.94 ft.) |
| RH Side | 893.0 mm (2.93 ft.) | |
Keep the drive shaft assembly level during inspection.
If the boots are stretched or contracted, correct them.