Home › Audio / Visual / Telematics › NAVIGATION / MULTI INFO DISPLAY › NAVIGATION SYSTEM(for Radio and Display Type) › 2014.10–2015.10
RM3090E _56 Audio / Visual / Telematics _008776 NAVIGATION / MULTI INFO DISPLAY _0148247 NAVIGATION SYSTEM(for Radio and Display Type) J

NAVIGATION / MULTI INFO DISPLAY  NAVIGATION SYSTEM(for Radio and Display Type)  Vehicle Position Mark Deviates Greatly  


PROCEDURE

1.CHECK CABIN
a.

Check the cabin for any object that might interrupt radio reception or additional devices which use radio waves on the instrument panel. If such an object exists, remove it and check if the GPS mark reappears.

HINT:

The GPS uses extremely weak radio waves originating from satellites. If the signal is interrupted by obstructions or other radio waves, the GPS may not be able to properly receive the signal.


OK:

The GPS mark appears.



Result:
Proceed to
OK
NG



OK

NORMAL OPERATION

NG

2.CHECK SURROUNDINGS
2.CHECK SURROUNDINGS
a.

Check if the vehicle is in a location where GPS signal reception is poor. If the vehicle is in such a place, relocate the vehicle and check if the GPS mark reappears.

HINT:

The GPS uses 24 satellites in 6 orbits. At any point in time, 4 satellites should be able to pinpoint your vehicle. However, GPS signals may not reach the vehicle due to influence from the surroundings, vehicle direction and time. For examples, see the following illustration.


I100196C22
0.167,0.094 0.385,0.292 0.219,0.198 10 *a 1.25,2.063 1.74,2.448 0.49,0.385 10 *b 3.333,2.146 4.073,2.604 0.74,0.458 10 *c 3.417,4.052 3.604,4.26 0.188,0.208 10 *f 1.208,3.99 1.406,4.188 0.198,0.198 10 *e 5.24,2.115 5.469,2.313 0.229,0.198 10 *d 5.5,4.073 5.688,4.281 0.188,0.208 10 *g
*a Example *b In a tunnel
*c In a building *d Under an overpass
*e On a forest or tree-lined path *f Between tall buildings
*g Under a cliff or overhang - -


OK:

The GPS mark is displayed.



Result:
Proceed to
OK
NG



OK

SYSTEM RETURNS TO NORMAL

NG

3.CHECK GPS INFORMATION (OPERATION CHECK)
3.CHECK GPS INFORMATION (OPERATION CHECK)
a.
E277814

Enter the "System Sensors Check" screen. Refer to Check System Sensors in Operation Check.

Click hereAudio / Visual / Telematics>NAVIGATION / MULTI INFO DISPLAY>NAVIGATION SYSTEM(for Radio and Display Type)>OPERATION CHECK


b.

Check how many of the following codes appear in the "Reception number" column.

HINT:

T or P appears.


OK:

At least 3 codes appear.



Result:
Proceed to
OK
NG



OK

4.CHECK VEHICLE SIGNAL (OPERATION CHECK)

NG

4.CHECK VEHICLE SIGNAL (OPERATION CHECK)
a.
E225801

Enter the "Vehicle Signal Check Mode" screen. Refer to Check Vehicle Signal in Operation Check.

Click hereAudio / Visual / Telematics>NAVIGATION / MULTI INFO DISPLAY>NAVIGATION SYSTEM(for Radio and Display Type)>OPERATION CHECK


b.

Check that the display changes between ON and OFF according to the shift lever operation.

OK:
Shift Lever Position Display
Except R OFF
R ON


HINT:

The display is updated once per second. It is normal for the display to lag behind the actual switch operation.



Result:
Proceed to
OK
NG



OK

NG

GO TO "REVERSE SIGNAL DOES NOT CHANGE IN VEHICLE SIGNAL CHECK MODE" IN PROBLEM SYMPTOMS TABLE