Home › Audio / Visual / Telematics › NAVIGATION / MULTI INFO DISPLAY › NAVIGATION SYSTEM(for Radio and Display Type) › 2014.10–2015.10
RM3090E _56 Audio / Visual / Telematics _008776 NAVIGATION / MULTI INFO DISPLAY _0148247 NAVIGATION SYSTEM(for Radio and Display Type) J

NAVIGATION / MULTI INFO DISPLAY  NAVIGATION SYSTEM(for Radio and Display Type)  Data Signal Circuit between Stereo Jack Adapter and Extension Module  


DESCRIPTION

The No. 1 stereo jack adapter assembly sends the sound data signal or image data signal from a USB device to the navigation ECU via this circuit.

WIRING DIAGRAM

E294736E03
1.563,0.74 2.021,0.896 0.458,0.156 10 false UDO- 1.531,1.323 1.99,1.479 0.458,0.156 10 false UDO+ 2.063,0.604 2.521,0.76 0.458,0.156 10 false 2 2.094,1.167 2.552,1.323 0.458,0.156 10 false 3 0.917,1.771 1.375,1.927 0.458,0.156 10 false G145 0.938,1.948 3.396,2.156 2.458,0.208 10 false No. 1 Stereo Jack Adapter Assembly 0.813,2.375 3.458,2.583 2.646,0.208 10 false : Data Signal (USB Communication Line) 5.219,0.729 5.677,0.885 0.458,0.156 10 false US1- 5.198,1.302 5.656,1.458 0.458,0.156 10 false US1+ 4.958,0.625 5.417,0.781 0.458,0.156 10 false 2 4.958,1.198 5.417,1.354 0.458,0.156 10 false 3 5.042,1.771 5.5,1.927 0.458,0.156 10 false A 5.031,1.938 6.083,2.135 1.052,0.198 10 false Navigation ECU

CAUTION / NOTICE / HINT

NOTICE:

Check that the wire harness is properly installed and does not have any sharp bends, pinching or loose connections.

Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING


PROCEDURE

1.CHECK HARNESS AND CONNECTOR (NAVIGATION ECU - NO. 1 STEREO JACK ADAPTER ASSEMBLY)
a.

Disconnect the A navigation ECU connector.


b.

Disconnect the G145 No. 1 stereo jack adapter assembly connector.


c.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
A-2 (US1-) - G145-2 (UDO-) Always Below 1 Ω
A-3 (US1+) - G145-3 (UDO+) Always Below 1 Ω
A-2 (US1-) - Body ground Always 10 kΩ or higher
A-3 (US1+) - Body ground Always 10 kΩ or higher



Result:
Proceed to
OK
NG



OK

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR