This circuit provides power to the radio and display receiver assembly.
Inspect the fuses for circuits related to this system before performing the following inspection procedure.
Check that the wire harness is properly installed and does not have any sharp bends, pinching or loose connections.
Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING
| *a | Front view of wire harness connector
(to Radio and Display Receiver Assembly) |
Disconnect the radio and display receiver assembly connectors.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| G141-7 (GND1) - Body ground | Always | Below 1 Ω |
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| G141-4 (+B1) - Body ground*1 | Always | 9.5 to 14 V |
| G141-4 (+B1) - Body ground*2 | Always | 11 to 14 V |
| G141-3 (ACC1) - Body ground*1 | Ignition switch ACC | 9.5 to 14 V |
| G141-3 (ACC1) - Body ground*2 | Ignition switch ACC | 11 to 14 V |
| G143-1 (IG) - Body ground | Ignition switch ON | 11 to 14 V |
*1: w/ Stop and Start System
*2: w/o Stop and Start System
| Proceed to |
|---|
| OK |
| NG |
OK
NG