Home › Power Source / Network › 3ZR-FAE BATTERY / CHARGING › CHARGING SYSTEM › from 2015.04
RM3090E _57 Power Source / Network _008394 3ZR-FAE BATTERY / CHARGING _0046852 CHARGING SYSTEM C

3ZR-FAE BATTERY / CHARGING  CHARGING SYSTEM  P1602  Deterioration of Battery  


DESCRIPTION

The battery condition is calculated from the voltage when the engine is running (except when cranking) and then output to the ECM. A DTC is output when battery degradation is determined based on this signal.

DTC No. Detection Item DTC Detection Condition Trouble Area Warning Indicate Memory
P1602 Deterioration of Battery Diagnosis condition: Engine running (except when cranking)
Malfunction status: Battery capacity is abnormally low for 10 seconds or more.
Other: 1 trip
·

Battery

·

Wire harness or connector


Not displayed DTC stored

WIRING DIAGRAM

A316097E07
0.219,0.396 1.271,0.74 1.052,0.344 10 false from Battery 3.688,0.583 4.854,1.031 1.167,0.448 10 false EFI-MAIN NO. 2 5.083,0.396 5.5,0.667 0.417,0.271 10 false A62 5.083,1.281 5.396,1.479 0.313,0.198 10 false B93 5.448,0.406 6.063,0.604 0.615,0.198 10 false BATT 5.156,0.198 5.313,0.396 0.156,0.198 10 false 1 5.448,1.292 5.76,1.49 0.313,0.198 10 false E1 5.135,1.083 5.448,1.281 0.313,0.198 10 false 59 5.479,2.115 5.99,2.396 0.51,0.281 10 false ECM

CAUTION / NOTICE / HINT

NOTICE:

Inspect the fuses for circuits related to this system before performing the following inspection procedure.


PROCEDURE

1.CHECK CHARGING SYSTEM

Result:
Result
OK
NG



OK

2.CHECK HARNESS AND CONNECTOR (POWER SOURCE CIRCUIT)

NG

REPAIR OR REPLACE CHARGING SYSTEM

2.CHECK HARNESS AND CONNECTOR (POWER SOURCE CIRCUIT)
a.
C267933C25
1.604,0.083 2.01,0.313 0.406,0.229 0.688,1.865 1.135,0.885 true 1.688,0.125 2.146,0.323 0.458,0.198 10 false A62 0.354,1.896 1.156,2.115 0.802,0.219 10 false 1 (BATT) 0.083,0.063 0.542,0.26 0.458,0.198 10 false *a
*a Front view of wire harness connector
(to ECM)


Disconnect the A62 ECM connector.


b.

Measure the voltage according to the value(s) in the table below.

Standard Voltage:
Tester Connection Condition Specified Condition
A62-1 (BATT) - Body ground Always 11 to 14 V



Result:
Result
OK
NG



OK

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR