84970
1.INSPECT STOP AND START SYSTEM CANCEL SWITCH (for 1AD-FTV)
| *a | Component without harness connected
(Stop and Start System Cancel Switch) |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
|---|---|---|
| 2 (ECU) - 4 (E) | Pushed | Below 1 Ω |
| Not pushed | 10 kΩ or higher |
If the result is not as specified, replace the stop and start system cancel switch.
| *a | Component without harness connected
(Stop and Start System Cancel Switch) |
Apply battery voltage between the terminals of the switch, and check the illumination condition of the stop and start system cancel switch.
| Measurement Condition | Specified Condition |
|---|---|
| Battery positive (+) → 1 (ILL+)
Battery negative (-) → 5 (ILL-) |
Illuminates |
If the result is not as specified, replace the stop and start system cancel switch.
84470
2.INSPECT STOP AND START SYSTEM CANCEL SWITCH (for 3ZR-FAE)
| *a | Component without harness connected
(Stop and Start System Cancel Switch) |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
|---|---|---|
| 8 (ECU) - 5 (E) | Pushed | Below 1 Ω |
| Not pushed | 10 kΩ or higher |
If the result is not as specified, replace the stop and start system cancel switch.
| *a | Component without harness connected
(Stop and Start System Cancel Switch) |
Apply battery voltage between the terminals of the switch, and check the illumination condition of the stop and start system cancel switch.
| Measurement Condition | Specified Condition |
|---|---|
| Battery positive (+) → 7 (ILL+)
Battery negative (-) → 6 (ILL-) |
Illuminates |
If the result is not as specified, replace the stop and start system cancel switch.