Home › Drivetrain › K114F MULTIDRIVE / CVT › FRONT DIFFERENTIAL OIL SEAL(for LH Side) › from 2015.04
RM3090E _52 Drivetrain _036009 K114F MULTIDRIVE / CVT _0172313 FRONT DIFFERENTIAL OIL SEAL(for LH Side) A

K114F MULTIDRIVE / CVT  FRONT DIFFERENTIAL OIL SEAL(for LH Side)  REPLACEMENT  


PROCEDURE

Hide 51410 1.REMOVE NO. 1 ENGINE UNDER COVER

Hide 51444A 2.REMOVE REAR ENGINE UNDER COVER LH

Hide 3.DRAIN CONTINUOUSLY VARIABLE TRANSAXLE FLUID

a.
C295552

Remove the refill plug and gasket from the continuously variable transaxle assembly.


b.
C296766

Using a 10 mm hexagon socket wrench, remove the drain plug and gasket from the transaxle oil (CVT) pan sub-assembly, and drain the fluid.


c.

Install a new gasket and the drain plug to the transaxle oil (CVT) pan sub-assembly.

Torque:
49 N*m (500 kgf*cm, 36 ft.*lbf)


d.

Temporarily install the gasket and refill plug to the continuously variable transaxle assembly.

HINT:

Reuse the old gasket. The refill plug will be removed again to adjust the fluid level.



Hide 43420H 5.REMOVE FRONT DRIVE SHAFT OIL SEAL LH

C295669N01
0.854,2.5 0.844,2.198 0.844,2.198 1.458,1.417 true 2.146,3.073 2.333,3.073 2.333,3.073 2.333,2.875 false 0.76,2.563 1.198,2.813 0.438,0.25 10 false SST 1.875,3 2.333,3.198 0.458,0.198 10 false SST

a.

Using SST, remove the front drive shaft oil seal LH from the continuously variable transaxle assembly.

SST
09308-00010  

NOTICE:

Do not damage the continuously variable transaxle assembly.



Hide 43420H 6.INSTALL FRONT DRIVE SHAFT OIL SEAL LH

a.

Apply MP grease to the lip of a new front drive shaft oil seal LH.


b.
C297222C03
1.177,1.458 1.177,0.521 1.177,0.521 2.75,0.521 true 2.125,0.875 2.125,0.521 true 2.802,0.458 3.26,0.656 0.458,0.198 10 true SST 2.031,2.865 2.344,3.021 0.313,0.156 10 false *a
*a -0.5 to 0.5 mm (-0.0197 to 0.0196 in.)


Using SST and a hammer, install the front drive shaft oil seal LH to the continuously variable transaxle assembly.

SST
09316-10010  
09950-70010  (09951-07150)

Standard depth:

-0.5 to 0.5 mm (-0.0197 to 0.0196 in.)


NOTICE:
·

Be sure to install the front drive shaft oil seal LH in the correct direction.

·

Make sure to install the front drive shaft oil seal LH as specified, otherwise malfunctions such as a fluid leak will occur.

·

Do not damage the lip of the front drive shaft oil seal LH.




Hide 8.ADD CONTINUOUSLY VARIABLE TRANSAXLE FLUID

Hide 9.INSPECT FOR FLUID LEAK

Hide 51444A 10.INSTALL REAR ENGINE UNDER COVER LH

Hide 51410 11.INSTALL NO. 1 ENGINE UNDER COVER