Home › Drivetrain › K114F MULTIDRIVE / CVT › OIL PRESSURE SENSOR › from 2015.04
RM3090E _52 Drivetrain _036009 K114F MULTIDRIVE / CVT _0172317 OIL PRESSURE SENSOR A

K114F MULTIDRIVE / CVT  OIL PRESSURE SENSOR  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the oil pressure sensor removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced:
Replacement Part or Procedure Necessary Procedures Effects/Inoperative when not Performed Link
Replacement of oil pressure sensor
·

Reset memory

·

Deceleration sensor zero point calibration

·

CVT oil pressure calibration


·

DTC P1589 is output (Malfunction Indicator Lamp (MIL) not iilluminated)

·

Deterioration of fuel efficiency


(Click here)


PROCEDURE

Hide 1.REMOVE FRONT WHEEL LH

Hide 51444A 2.REMOVE REAR ENGINE UNDER COVER LH

Hide 89637K 3.REMOVE OIL PRESSURE SENSOR

C296018

a.

Disconnect the oil pressure sensor connector.


b.
C328303N01
1.531,0.688 1.531,0.313 1.531,0.313 1.885,0.313 true 1.948,0.219 2.406,0.417 0.458,0.198 10 true SST

Using SST, remove the oil pressure sensor from the continuously variable transaxle assembly.

SST
09326-22011