Home › Drivetrain › K114F MULTIDRIVE / CVT › PATTERN SELECT SWITCH › 2015.04–2015.10
RM3090E _52 Drivetrain _036009 K114F MULTIDRIVE / CVT _0172322 PATTERN SELECT SWITCH G

K114F MULTIDRIVE / CVT  PATTERN SELECT SWITCH  INSPECTION  


PROCEDURE

Hide 84970 1.INSPECT COMBINATION SWITCH ASSEMBLY

a.
C277027C03
1.292,1.729 1.5,1.385 true 2.104,1.729 1.865,1.385 true 1.073,1.781 1.688,1.979 0.615,0.198 10 MSW2 1.938,1.781 2.552,1.979 0.615,0.198 10 MSW1 0.104,0.104 0.719,0.302 0.615,0.198 10 *a
*a Component without harness connected
(Combination Switch Assembly)


Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Switch Condition Specified Condition
2 (MSW1) - 4 (MSW2) Combination switch (SPORT) on Below 1 Ω
2 (MSW1) - 4 (MSW2) Combination switch (SPORT) off 10 kΩ or higher


If the result is not as specified, replace the combination switch assembly.