The airbag sensor assembly has a built-in yaw rate and acceleration sensor.
The skid control ECU (brake actuator assembly) receives signals from the yaw rate and acceleration sensor (airbag sensor assembly) via the CAN communication system.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| C1442 | Invalid Data Received from Acceleration Sensor | Both of the following is condition is met.
1.
With the IG1 terminal voltage between 9.5 and 17.4 V. 2.
An invalid data signal is transmitted continuously from the acceleration sensor for 10 seconds or more. |
Acceleration sensor (Airbag sensor assembly) |
| C1443 | Invalid Data Received from Yaw Rate Sensor | Both of the following is condition is met.
1.
With the IG1 terminal voltage between 9.5 and 17.4 V. 2.
An invalid data signal is transmitted continuously from the yaw rate sensor for 10 seconds or more. |
Yaw rate sensor (Airbag sensor assembly) |
When replacing the yaw rate and acceleration sensor (airbag sensor assembly), perform zero point calibration.
Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM>CALIBRATION
When replacing the yaw rate and acceleration sensor (airbag sensor assembly), perform acceleration sensor zero point calibration and CVT oil pressure calibration (for continuously variable transaxle).
K111: Click hereDrivetrain>K111 MULTIDRIVE / CVT>CONTINUOUSLY VARIABLE TRANSAXLE SYSTEM>INITIALIZATION
K111F: Click hereDrivetrain>K111F MULTIDRIVE / CVT>CONTINUOUSLY VARIABLE TRANSAXLE SYSTEM>INITIALIZATION
K114F: Click hereDrivetrain>K114F MULTIDRIVE / CVT>CONTINUOUSLY VARIABLE TRANSAXLE SYSTEM>INITIALIZATION
Clear the DTCs.
Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM>DTC CHECK / CLEAR
Turn the ignition switch off.
Start the engine and idle it for 60 seconds, and then stop the engine.
Check if the same DTC is output.
Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM>DTC CHECK / CLEAR
| Proceed to |
|---|
| DTCs C1442 and/or C1443 are output |
| DTCs C1442 and C1443 are not output |
DTCs C1442 and/or C1443 are output
DTCs C1442 and C1443 are not output
Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING