| Part Tightened | N*m | kgf*cm | ft.*lbf | |||
|---|---|---|---|---|---|---|
| Valve rocker arm lost motion damper sub-assembly x Camshaft housing sub-assembly | 10 | 102 | 7 | |||
| Camshaft housing sub-assembly x Cylinder head sub-assembly | 27 | 275 | 20 | |||
| Camshaft timing exhaust gear assembly x No. 2 camshaft | 54 | 551 | 40 | |||
| Camshaft timing gear assembly x Camshaft | 54 | 551 | 40 | |||
| Part Tightened | N*m | kgf*cm | ft.*lbf | |||
|---|---|---|---|---|---|---|
| Cylinder head sub-assembly x Cylinder block | 1st | 49 | 500 | 36 | ||
| 2nd | 90° | |||||
| 3rd | 45° | |||||
| No. 1 water by-pass pipe x Cylinder block | 21 | 214 | 15 | |||
| Part Tightened | N*m | kgf*cm | ft.*lbf | |||
|---|---|---|---|---|---|---|
| Crankshaft pulley x Crankshaft | 190 | 1937 | 140 | |||
| Part Tightened | N*m | kgf*cm | ft.*lbf | |||
|---|---|---|---|---|---|---|
| Drive plate and ring gear sub-assembly x Crankshaft | 88 | 897 | 65 | |||
| Flywheel sub-assembly x Crankshaft | 1st | 49 | 500 | 36 | ||
| 2nd | 90° | |||||
| Part Tightened | N*m | kgf*cm | ft.*lbf | in.*lbf | |||
|---|---|---|---|---|---|---|---|
| Engine hanger x Cylinder head sub-assembly | 43 | 438 | 32 | ||||
| Engine mounting insulator LH x Body | 95 | 969 | 70 | ||||
| Wire harness clamp bracket x Engine mounting insulator LH | 7.7 | 79 | 68 | ||||
| Engine mounting insulator sub-assembly RH x Body | 95 | 969 | 70 | ||||
| Radiator reservoir bracket x Engine mounting insulator sub-assembly RH | 5.0 | 51 | 44 | ||||
| Rear engine mounting insulator x Front suspension crossmember sub-assembly | 95 | 969 | 70 | ||||
| Drive shaft bearing bracket x Cylinder block | 64 | 653 | 47 | ||||
| Engine mounting insulator LH x Engine mounting bracket LH | 56 | 571 | 41 | ||||
| Engine mounting insulator sub-assembly RH x Engine mounting bracket RH | for bolt and nut A | 95 | 969 | 70 | |||
| for nut B | 52 | 530 | 38 | ||||
| Front suspension crossmember sub-assembly x Body | 137 | 1397 | 101 | ||||
| Front suspension member brace rear x Body | for bolt A | 137 | 1397 | 101 | |||
| for bolt B | 93 | 948 | 69 | ||||
| Air fuel ratio sensor bracket x Cylinder head | 39 | 398 | 29 | ||||
| Front crossmember sub-assembly x Body | 99 | 1010 | 73 | ||||
| Front crossmember sub-assembly x Front engine mounting insulator | 95 | 969 | 70 | ||||
| Rear engine mounting insulator x Rear engine mounting bracket | 95 | 969 | 70 | ||||
| Front engine mounting insulator x Front engine mounting bracket | 145 | 1479 | 107 | ||||
| Front suspension member reinforcement LH x Front crossmember sub-assembly | 99 | 1010 | 73 | ||||
| Front suspension member reinforcement LH x Front suspension crossmember sub-assembly | 99 | 1010 | 73 | ||||
| Front suspension member reinforcement RH x Front crossmember sub-assembly | 99 | 1010 | 73 | ||||
| Front suspension member reinforcement RH x Front suspension crossmember sub-assembly | 99 | 1010 | 73 | ||||
| Clutch hose x Accumulator to flexible hose tube | 15 | 153 | 11 | ||||
| Transmission control cable assembly x Continuously variable transaxle assembly | 5.0 | 51 | 44 | ||||
| Transmission control cable assembly x Transmission control cable support | 12 | 122 | 9 | ||||
| Transmission control cable assembly x Control shaft lever | 12 | 122 | 9 | ||||
| Engine wire x Manual transaxle | 19 | 194 | 14 | ||||
| Starter wire x Starter assembly | 9.8 | 100 | 87 | ||||
| Engine wire and Engine room main wire x Battery positive terminal | 7.5 | 76 | 66 | ||||
| Engine wire x Body | 11.4 | 116 | 8 | ||||
| Engine wire x Engine room No. 1 junction block | 12.8 | 131 | 9 | ||||
| Engine wire x Body | 8.4 | 86 | 74 | ||||
| Compressor stud bolt x Cylinder block | 9.8 | 100 | 87 | ||||
| Compressor with pulley assembly x Cylinder block | 25 | 255 | 18 | ||||
| Radiator reservoir assembly x Radiator reservoir bracket | 5.0 | 51 | 44 | ||||
| No. 2 engine under cover x Front suspension crossmember sub-assembly | 5.5 | 56 | 49 | ||||
| Part Tightened | N*m | kgf*cm | ft.*lbf | in.*lbf | |||
|---|---|---|---|---|---|---|---|
| Stud bolt (for stiffening crankcase) | 5.0 | 51 | 44 | ||||
| Stud bolt (for water inlet housing) | 5.0 | 51 | 44 | ||||
| Stud bolt (for No. 3 water by-pass pipe) | 5.0 | 51 | 44 | ||||
| Stud bolt (for camshaft housing sub-assembly) | 9.5 | 97 | 84 | ||||
| Stiffening crankcase assembly x Cylinder block | 21 | 214 | 15 | ||||
| Oil pan drain plug x No. 2 oil pan sub-assembly | 37 | 377 | 27 | ||||
| No. 1 taper screw plug x Cylinder block | 25 | 255 | 18 | ||||
| Continuously variable valve lift controller assembly x Camshaft housing sub-assembly | 18 | 184 | 13 | ||||
| No. 1 chain vibration damper x Cylinder block | 21 | 214 | 15 | ||||
| No. 1 generator bracket x Cylinder block | 24 | 245 | 18 | ||||
| Water inlet housing x Timing chain cover | 10 | 102 | 7 | ||||
| Stud bolt (for engine mounting bracket) | 10 | 102 | 7 | ||||
| No. 1 chain tensioner assembly x Timing chain cover | 12 | 122 | 9 | ||||
| Cylinder head cover sub-assembly x Camshaft housing sub-assembly | 10 | 102 | 7 | ||||
| Engine cover joint x Cylinder head cover sub-assembly | 10 | 102 | 7 | ||||
| V-ribbed belt tensioner assembly x Timing chain cover sub-assembly | 21 | 214 | 15 | ||||
| No. 1 vacuum pump bracket x Camshaft housing sub-assembly | 21 | 214 | 15 | ||||
| No. 1 water by-pass pipe x Cylinder block | 21 | 214 | 15 | ||||
| No. 1 seal plate x Cylinder block | 10 | 102 | 7 | ||||
| No. 3 water by-pass pipe x Cylinder block | 10 | 102 | 7 | ||||
| Engine oil level dipstick guide x Cylinder block | 21 | 214 | 15 | ||||
| Part Tightened | N*m | kgf*cm | ft.*lbf | in.*lbf | |||
|---|---|---|---|---|---|---|---|
| Stud bolt | 9.5 | 97 | 84 | ||||
| No. 2 straight screw plug x Cylinder head | 44 | 449 | 32 | ||||
| Part Tightened | N*m | kgf*cm | ft.*lbf | in.*lbf | |||
|---|---|---|---|---|---|---|---|
| Stud bolt | 5.0 | 51 | 44 | ||||
| No. 1 taper screw plug x Cylinder block | 43 | 438 | 32 | ||||
| No. 1 oil nozzle x Cylinder block | 10 | 102 | 7 | ||||
| Crankshaft bearing cap x Cylinder block | 1st | 40 | 408 | 30 | |||
| 2nd | 90° | ||||||
| Connecting rod bearing cap x Connecting rod | 1st | 20 | 204 | 15 | |||
| 2nd | 90° | ||||||
| Ventilation case x Cylinder block | 10 | 102 | 7 | ||||