Home › Engine / Hybrid System › 2WW ENGINE CONTROL › ECD SYSTEM › from 2015.10
RM3090E _51 Engine / Hybrid System _044372 2WW ENGINE CONTROL _0208480 ECD SYSTEM C

2WW ENGINE CONTROL  ECD SYSTEM  U0129  Lost Communication with Brake System Control Module  


DESCRIPTION

The ECM and skid control ECU (brake actuator assembly) communicate with each other via the CAN communication line

If there is a problem in this communication, the ECM stores the DTC.

DTC No. Detection Item DTC Detection Condition Trouble Area MIL Memory
U0129 Lost Communication with Brake System Control Module No communication between ECM and skid control ECU.
(1 trip detection logic)
·

Wire harness (CANL and CANH circuits)

·

ECM

·

Skid control ECU (brake actuator assembly)


Comes on DTC stored

WIRING DIAGRAM

A256281E05
0.177,2.958 3.438,3.281 3.26,0.323 10 false Skid Control ECU (Brake Actuator Assembly) 6.115,2.917 7.156,3.292 1.042,0.375 10 false ECM 1.604,0.802 2.052,0.99 0.448,0.188 10 false A80 1.604,2.26 2.021,2.458 0.417,0.198 10 false A80 5.427,2.26 5.917,2.479 0.49,0.219 10 false A62 5.438,0.802 5.969,1.063 0.531,0.26 10 false A62 5.479,0.615 5.792,0.813 0.313,0.198 10 false 26 5.49,2.073 5.792,2.323 0.302,0.25 10 false 25 1.656,0.615 2.01,0.844 0.354,0.229 10 false 22 1.635,2.083 1.979,2.323 0.344,0.24 10 false 10 1.115,0.802 1.865,1.021 0.75,0.219 10 false CANH 1.146,2.281 1.771,2.573 0.625,0.292 10 false CANL 5.781,0.771 6.396,1.042 0.615,0.271 10 false CANH 5.781,2.26 6.448,2.521 0.667,0.26 10 false CANL

CAUTION / NOTICE / HINT

NOTICE:

When replacing the ECM, the ECM needs registration and initialization.


HINT:
·

When a DTC indicating a CAN communication system malfunction is output, repair the CAN communication system before repairing each corresponding sensor.

·

Read freeze frame data using the GTS. Freeze frame data records the engine condition when malfunctions are detected. When troubleshooting, freeze frame data can help determine if the vehicle was moving or stationary, if the engine was warmed up or not, and other data from the time the malfunction occurred.

·

If the CAN communication malfunctions, there is no data output from the ECM. In this case, some of the freeze frame data is not correct and not identical to the ECM data. However the ECM data is correct.

·

When the ECM must be replaced, before replacing the ECM, perform the "Learning Values Save" function using the GTS. Then after installing the new ECM, perform all of the initialization/registrations for the "Learning Values Write" function by following the instructions shown on the GTS display.



PROCEDURE

1.GO TO CAN COMMUNICATION SYSTEM
a.

Go to CAN communication system for troubleshooting.



Result:
Proceed to
NEXT



NEXT

END