Home › Engine / Hybrid System › 2WW ENGINE CONTROL › DIESEL THROTTLE BODY › from 2015.10
RM3090E _51 Engine / Hybrid System _044372 2WW ENGINE CONTROL _0208481 DIESEL THROTTLE BODY A

2WW ENGINE CONTROL  DIESEL THROTTLE BODY  REMOVAL  


PROCEDURE

Hide 16400 1.REMOVE RADIATOR ASSEMBLY

Hide 2.REMOVE WIRE HARNESS CLAMP BRACKET

a.
A349789

Detach the 2 clamps.


b.
A316487N01
1.823,0.156 1.979,0.354 0.156,0.198 10 true A 2.156,1.115 2.313,1.313 0.156,0.198 10 true A 2.375,1.719 2.531,1.917 0.156,0.198 10 true B

Using a T27 "TORX" socket wrench, remove the 2 bolts (A).


c.

Remove the bolt (B) and wire harness clamp bracket.


Hide 17343D 3.REMOVE NO. 3 AIR HOSE

a.
A315729

Loosen the hose clamp and remove the No. 3 air hose from the air tube assembly.


Hide 22030 4.REMOVE DIESEL THROTTLE BODY ASSEMBLY

a.
A349792C01
1.792,0.75 1.927,0.281 1.927,0.281 2.344,0.281 true 0.896,1.948 1.198,1.948 1.198,1.948 1.667,1.406 true 0.74,1.844 1.052,2 0.313,0.156 10 false *1 2.365,0.188 2.625,0.385 0.26,0.198 10 true *2
*1 Water By-pass Hose Assembly
*2 Radiator Hose Sub-assembly


Disconnect the water by-pass hose assembly and radiator hose sub-assembly from the air tube assembly.


b.
A382972

Detach the 2 wire harness clamps.


c.
A349793

Disconnect the intake air temperature sensor connector.


d.
A316488

Disconnect the No. 7 engine wire connector and detach the clamp.


e.
A349795

Using a T27 "TORX" socket wrench, remove the bolt and disconnect the air tube assembly from the cylinder block sub-assembly.


f.
A315728

Using an E8 "TORX" socket wrench, remove the 3 bolts, diesel throttle body assembly with air tube assembly and gasket from the intake manifold.

NOTICE:

Avoid physical shock to the diesel throttle body assembly.



g.

Detach the 2 claws and remove the air tube assembly from the diesel throttle body assembly.


h.

Remove the gasket from the air tube assembly.


i.
A316489

Disconnect the diesel throttle body assembly connector.