Home › Engine / Hybrid System › 2WW ENGINE CONTROL › ACCELERATOR PEDAL › from 2015.10
RM3090E _51 Engine / Hybrid System _044372 2WW ENGINE CONTROL _0208483 ACCELERATOR PEDAL G

2WW ENGINE CONTROL  ACCELERATOR PEDAL  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 78110K 1.INSPECT ACCELERATOR PEDAL SENSOR ASSEMBLY

a.

Connect the GTS to the DLC3.


b.

Turn the ignition switch to ON.


c.

Turn the GTS on.


d.

Enter the following menus: Powertrain / Engine and ECT / Data List / Accel Sens. No.1 Volt % and Accel Sens. No.2 Volt %.

Powertrain > Engine and ECT > Data List
Tester Display
Accel Sens. No.1 Volt %
Accel Sens. No.2 Volt %
50003 371 11,12

e.

Read the values displayed on the GTS.

Standard Percentage:
Tester Display Condition Specified Condition
Accel Sens. No.1 Volt % Accelerator pedal released 10 to 22%
Accelerator pedal fully depressed 52 to 90%
Accel Sens. No.2 Volt % Accelerator pedal released 24 to 40%
Accelerator pedal fully depressed 68 to 99%


If the result is not as specified, check the accelerator pedal sensor assembly, wire harness and ECM.