Home › Engine / Hybrid System › 2WW ENGINE CONTROL › MASS AIR FLOW METER › from 2015.10
RM3090E _51 Engine / Hybrid System _044372 2WW ENGINE CONTROL _0208484 MASS AIR FLOW METER G

2WW ENGINE CONTROL  MASS AIR FLOW METER  INSPECTION  


PROCEDURE

Hide 22204 1.INSPECT MASS AIR FLOW METER SUB-ASSEMBLY

a.
A316500C01
1.188,1.24 1.427,1.896 1.427,1.896 1.688,1.896 true 1.052,1.156 1.167,0.375 1.167,0.375 1.344,0.375 true 0.073,0.083 0.365,0.271 0.292,0.188 10 false *a 1.75,1.802 2.208,2 0.458,0.198 10 false E2G 1.406,0.271 1.865,0.469 0.458,0.198 10 false THA
*a Component without harness connected
(Mass Air Flow Meter Sub-assembly)


Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
3 (THA) - 2 (E2G) -20°C (-4°F) 12900 to 14700 Ω
20°C (68°F) 2300 to 2500 Ω
60°C (140°F) 587 to 625 Ω


If the result is not as specified, replace the mass air flow meter sub-assembly.