Home › Engine / Hybrid System › 2WW ENGINE CONTROL › ENGINE COOLANT TEMPERATURE SENSOR › from 2015.10
RM3090E _51 Engine / Hybrid System _044372 2WW ENGINE CONTROL _0208487 ENGINE COOLANT TEMPERATURE SENSOR G

2WW ENGINE CONTROL  ENGINE COOLANT TEMPERATURE SENSOR  INSPECTION  


PROCEDURE

Hide 89422C 1.INSPECT ENGINE COOLANT TEMPERATURE SENSOR

a.
A316501C01
0.115,0.083 0.427,0.24 0.313,0.156 10 false *a
*a Component without harness connected
(Engine Coolant Temperature Sensor)


Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
1 - 2 -40°C (-40°F) 73508 to 78016 Ω
-20°C (-4°F) 21293 to 22417 Ω
0°C (32°F) 7188 to 7515 Ω
20°C (68°F) 2758 to 2866 Ω
40°C (104°F) 1179 to 1219 Ω
60°C (140°F) 552 to 568 Ω
80°C (176°F) 280 to 286 Ω
100°C (212°F) 151 to 154 Ω
120°C (248°F) 86 to 89 Ω


NOTICE:

If checking the engine coolant temperature sensor in water, be careful not to allow water to contact the terminals. After checking, wipe the water off the engine coolant temperature sensor.


If the result is not as specified, replace the engine coolant temperature sensor.