Home › Engine / Hybrid System › 2WW ENGINE CONTROL › RELAY › from 2015.10
RM3090E _51 Engine / Hybrid System _044372 2WW ENGINE CONTROL _0208493 RELAY G

2WW ENGINE CONTROL  RELAY  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 85915Q 1.INSPECT EFI MAIN RELAY (EFI MAIN)

A273391N02
2.667,0.74 2.927,0.74 true 2.531,1.125 2.948,1.125 true 2.531,1.625 2.948,1.625 true 1.708,0.74 1.969,0.74 true 0.229,1.313 0.385,1.51 0.156,0.198 10 1 1.188,1.313 1.344,1.51 0.156,0.198 10 2 0.219,0.781 0.375,0.979 0.156,0.198 10 3 1.188,0.771 1.344,0.969 0.156,0.198 10 5 3,1.052 3.156,1.25 0.156,0.198 10 5 1.604,0.667 1.76,0.865 0.156,0.198 10 1 2.99,0.667 3.146,0.865 0.156,0.198 10 2 3,1.552 3.156,1.75 0.156,0.198 10 3

a.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
3 - 5 Battery voltage not applied between terminals 1 and 2 10 kΩ or higher
Battery voltage applied between terminals 1 and 2 Below 1 Ω


If the result is not as specified, replace the EFI MAIN relay.


Hide 28610 2.INSPECT FUEL HTR RELAY

a.
A201709N01
1.833,0.417 2,0.417 2,0.417 2.292,1.135 true 3,0.417 2.833,0.417 2.833,0.417 2.583,1.135 true 1.833,1.833 2,1.833 2,1.833 2.292,1.365 true 3,1.833 2.833,1.833 2.833,1.833 2.594,1.365 true 0.417,1.219 0.573,1.417 0.156,0.198 10 4 1.271,1.219 1.427,1.417 0.156,0.198 10 3 1.271,0.813 1.427,1.01 0.156,0.198 10 2 0.417,0.802 0.573,1 0.156,0.198 10 1 1.729,0.333 1.885,0.531 0.156,0.198 10 4 3.031,0.333 3.188,0.531 0.156,0.198 10 3 3.042,1.74 3.198,1.938 0.156,0.198 10 2 1.74,1.74 1.896,1.938 0.156,0.198 10 1

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
1 - 2 Battery voltage not applied terminals 3 and 4 10 kΩ or higher
Battery voltage applied terminals 3 and 4 Below 1 Ω


If the result is not as specified, replace the FUEL HTR relay.