Home › Engine / Hybrid System › 2WW EMISSION CONTROL › EGR VALVE › from 2015.10
RM3090E _51 Engine / Hybrid System _044375 2WW EMISSION CONTROL _0210861 EGR VALVE G

2WW EMISSION CONTROL  EGR VALVE  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 25620 1.INSPECT EGR VALVE ASSEMBLY OPERATION

a.

Connect the GTS to the DLC3.


b.

Turn the ignition switch to ON and turn the GTS on.


c.

Start the engine.


d.

Enter the following menus: Powertrain / Engine and ECT / Active Test / Actuator Test of EGR-Valve / Data List / Target EGR Pos. and Actual EGR Valve Pos.

Powertrain > Engine and ECT > Active Test
Active Test Display
Actuator Test of EGR-Valve
Data List Display
Target EGR Valve Pos
Actual EGR Valve Pos
50004 371 2 23,24

e.

Perform the following steps 1 to 4.


f.

Step 1

i.

Perform Actuator Test of EGR-Valve with control value of 0% (opening ratio in %).


ii.

Monitor the difference of the control value and EGR valve Actuator Position value (0 +/- 3%). EGR valve must operate within 1 second.



g.

Step 2

i.

Wait for 2 seconds or more.



h.

Step 3

i.

Perform Actuator Test of EGR-Valve with control value of 94% (opening ratio in %).


ii.

Monitor the difference of the control value and EGR valve Actuator Position value (0 +/- 3%). EGR valve must operate within 1 second.



i.

Step 4

i.

Wait for 2 seconds or more.



j.

Perform the above steps 1 to 4 and check that the part operates as specified.

OK:

Part operates as specified.