Home › Engine / Hybrid System › 2WW EMISSION CONTROL › EGR BYPASS VALVE SWITCHING VALVE › from 2015.10
RM3090E _51 Engine / Hybrid System _044375 2WW EMISSION CONTROL _0210863 EGR BYPASS VALVE SWITCHING VALVE G

2WW EMISSION CONTROL  EGR BYPASS VALVE SWITCHING VALVE  INSPECTION  


PROCEDURE

Hide 25860D 1.INSPECT EGR BYPASS VALVE SWITCHING VALVE

a.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
1 - 2 23°C (73°F) 28.3 to 31.1 Ω


If the result is not as specified, replace the EGR bypass valve switching valve assembly.


b.

Check EGR bypass valve switching valve assembly operation.

i.
A317654C01
0.583,0.835 0.771,1.009 0.188,0.174 10 *b 0.526,1.427 0.715,1.601 0.188,0.174 10 *c 1.038,0.027 1.227,0.201 0.188,0.174 10 *a 0.803,0.92 0.951,0.92 0.951,0.92 1.433,1.101 false 0.742,1.517 0.913,1.517 0.913,1.517 1.199,1.718 false
*a Air
*b Port (A)
*c Port (B)


Check that air does not flow from the port (A) to the port (B).



c.
A317655C01
0.096,0.879 0.276,1.045 0.180,0.166 10 *b 0.105,1.429 0.285,1.596 0.180,0.166 10 *c 0.485,0.035 0.665,0.201 0.180,0.166 10 *a 0.322,0.971 0.431,0.971 0.431,0.971 0.878,1.111 false 0.317,1.526 0.434,1.526 0.434,1.526 0.648,1.719 false 1.46,0.132 1.588,0.295 0.128,0.163 10 2 2.383,0.398 2.511,0.561 0.128,0.163 10 1 1.782,0.485 1.669,0.222 1.669,0.222 1.598,0.222 false 1.931,0.572 2.248,0.492 2.248,0.492 2.355,0.492 false
*a Air
*b Port (A)
*c Port (B)


Apply battery voltage to the terminals as shown in the illustration.


d.

Check that air flows from the port (A) to the port (B).

If the result is not as specified, replace the EGR bypass valve switching valve assembly.