Home › Engine / Hybrid System › 2WW EMISSION CONTROL › EGR GAS TEMPERATURE SENSOR › from 2015.10
RM3090E _51 Engine / Hybrid System _044375 2WW EMISSION CONTROL _0210864 EGR GAS TEMPERATURE SENSOR A

2WW EMISSION CONTROL  EGR GAS TEMPERATURE SENSOR  INSTALLATION  


PROCEDURE

Hide 1.INSTALL EGR GAS TEMPERATURE SENSOR

a.
A354704C01
2.823,0.74 3.219,1.031 0.396,0.292 10 false *a
*a Torque Wrench Fulcrum Length


Using a 14 mm union nut wrench, install the EGR gas temperature sensor.

Torque:
Specified tightening torque : 30 N*m (306 kgf*cm, 22 ft.*lbf)

NOTICE:

If the EGR gas temperature sensor is dropped, replace it with a new one.


HINT:
·

Calculate the torque wrench reading when changing the fulcrum length of the torque wrench.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION

·

When using a 14 mm union nut wrench (fulcrum length of 25 mm (0.984 in.)) + torque wrench (fulcrum length of 300 mm (11.8 in.)): 28 N*m (286 kgf*cm, 21 ft.*lbf)




b.

Connect the EGR gas temperature sensor connector and slide the white-colored lock to engage it securely.