Home › Engine / Hybrid System › 2WW INTAKE / EXHAUST › INTAKE SYSTEM › from 2015.10
RM3090E _51 Engine / Hybrid System _044376 2WW INTAKE / EXHAUST _0210930 INTAKE SYSTEM G

2WW INTAKE / EXHAUST  INTAKE SYSTEM  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 1.INSPECT INTAKE SYSTEM

a.

Check that there are no vacuum leaks at the points shown in the illustration.

A365371C01
1.094,0.167 1.469,0.448 0.375,0.281 12 false *A
*A for RHD - -


A337399


Hide 2.INSPECT INTAKE MANIFOLD

a.

Inspect the swirl control valve operation.

i.

Connect the GTS to the DLC3.


ii.

Turn the ignition switch to ON and turn the GTS on.


iii.

Start the engine.


iv.

Enter the following menus: Powertrain / Engine and ECT / Active Test / Actuator Test of Swirl Flap / Data List / Swirl Valve Actuator Position.

Powertrain > Engine and ECT > Active Test
Tester Display
Actuator Test of Swirl Flap
50004 371 7
OK:

The value of "Swirl Valve Actuator Position" changes according to the amount "Actuator Test of Swirl Flap" is operated, and the swirl flap operates smoothly.




Hide 3.CHECK INTAKE AIR CONTROL SYSTEM

a.

Check for leakage or clogging between the air cleaner assembly housing and turbocharger sub-assembly inlet, and between the turbocharger sub-assembly outlet and cylinder head sub-assembly.

Condition Operation
Clogged air cleaner assembly Clean or replace air cleaner filter element sub-assembly
Hoses collapsed or deformed Repair or replace
Leakage from connections Check each connection and repair
Cracks in components Check and repair or replace


Hide 4.CHECK EXHAUST SYSTEM

a.

Check for leakage or clogging between the cylinder head sub-assembly and turbocharger sub-assembly inlet and between the turbocharger sub-assembly outlet and exhaust pipe assembly.

Condition Operation
Deformed components Repair or replace
Foreign material in passages Remove
Leakage from components Repair or replace
Cracks in components Check and repair or replace