Home › Engine / Hybrid System › 2WW INTAKE / EXHAUST › EXHAUST MANIFOLD W/ TURBOCHARGER › from 2015.10
RM3090E _51 Engine / Hybrid System _044376 2WW INTAKE / EXHAUST _0210932 EXHAUST MANIFOLD W/ TURBOCHARGER G

2WW INTAKE / EXHAUST  EXHAUST MANIFOLD W/ TURBOCHARGER  INSPECTION  


PROCEDURE

Hide 17201 1.VISUALLY CHECK TURBOCHARGER SUB-ASSEMBLY

a.

Check for deformation and cracks in the turbine wheel on the exhaust side.

A347247C01
0.729,1.417 2.104,1.417 true 0.49,1.323 0.854,1.646 0.365,0.323 10 false *a
*a Turbine Wheel - -


If the turbine wheel is cracked or deformed, replace the turbocharger sub-assembly.


Hide 17201 2.CHECK TURBINE SHAFT ROTATION

a.
A347248

Rotate the turbine wheel on the exhaust side with your finger and check that it rotates smoothly. If the turbine wheel does not rotate smoothly, replace the turbocharger sub-assembly.

If the turbine wheel does not rotate smoothly, replace the turbocharger sub-assembly.

HINT:

Due to the viscosity of the oil, it may take a little effort to rotate the turbine wheel. This is not a problem.



b.
A347249

Move the turbine wheel as shown in the illustration and check that there is no looseness in the shaft and that the turbine wheel does not contact the housing.

If there is any contact with the housing or obvious looseness in the shaft, replace the turbocharger sub-assembly.

HINT:

A clearance of 100 μm exists between the turbine shaft and bearings. If it is difficult to judge the looseness of the turbine shaft, perform the same inspection on another vehicle which has the same turbocharger and compare the clearance.