Home › Engine / Hybrid System › 2WW COOLING › COOLING SYSTEM › from 2015.10
RM3090E _51 Engine / Hybrid System _044377 2WW COOLING _0211203 COOLING SYSTEM G

2WW COOLING  COOLING SYSTEM  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 1.INSPECT FOR COOLANT LEAK

CAUTION:

Do not remove the reservoir cap while the engine and radiator assembly are still hot. Pressurized hot engine coolant and steam may be released and cause serious burns.


a.

Remove the reservoir cap.


b.
A377303C01
2.333,1.719 2.167,1.719 2.167,1.719 2.167,1.302 true 2.385,1.625 2.698,1.823 0.313,0.198 10 true *a
*a Radiator Cap Tester


Fill the radiator reserve tank assembly with engine coolant, and then install a radiator cap tester.


c.

Warm up the engine.


d.

Pump the radiator cap tester to 143 kPa (1.5 kgf/cm2, 21 psi), and then check that the pressure does not drop.

·

If the pressure drops, check the hoses, radiator assembly and engine water pump assembly for leaks.

·

If there are no signs of external engine coolant leaks, check the heater core, cylinder block sub-assembly and cylinder head sub-assembly.



e.

Remove the radiator cap tester.


f.

Install the reservoir cap.


Hide 2.INSPECT ENGINE COOLANT LEVEL IN RESERVOIR

a.
A377304C01
1.802,0.813 2.219,0.229 2.219,0.229 2.385,0.229 true 1.75,1.021 2.073,1.521 2.073,1.521 2.24,1.521 true 2.438,0.135 2.75,0.333 0.313,0.198 10 false *a 2.302,1.438 2.615,1.635 0.313,0.198 10 false *b
*a Full Line
*b Low Line


Check that the engine coolant level is between the low line and full line when the engine is cold.

If the engine coolant level is low, check for leaks and add engine coolant to the full line.

NOTICE:

Do not substitute plain water for engine coolant.



Hide 3.INSPECT ENGINE COOLANT QUALITY

CAUTION:

Do not remove the reservoir cap while the engine and radiator assembly are still hot. Pressurized hot engine coolant and steam may be released and cause serious burns.


a.

Remove the reservoir cap.


b.

Check that there are no excessive deposits of rust or scale around the reservoir cap and water filler hole. Also, the engine coolant should be free of oil.

If excessively dirty, clean the engine coolant passage and replace the engine coolant.


c.

Install the reservoir cap.