Home › Engine / Hybrid System › 2WW COOLING › THERMOSTAT › from 2015.10
RM3090E _51 Engine / Hybrid System _044377 2WW COOLING _0211207 THERMOSTAT G

2WW COOLING  THERMOSTAT  INSPECTION  


PROCEDURE

Hide 16331A 1.INSPECT THERMOSTAT

a.

Immerse the thermostat in water, and then gradually heat the water.


b.

Check the valve opening temperature of the thermostat.

Standard valve opening temperature:

100 °C (212 °F)


If the valve opening temperature is not as specified, replace the thermostat.


c.

Check that the valve is fully closed when the thermostat is at a low temperature (below 88°C (190°F)).

If not fully closed, replace the thermostat.